Draper Nocturne + E 220V Talimatlar Kurulum ve Çalıştırma - Sayfa 3
Projeksiyon Perdesi Draper Nocturne + E 220V için çevrimiçi göz atın veya pdf Talimatlar Kurulum ve Çalıştırma indirin. Draper Nocturne + E 220V 12 sayfaları. Outdoor electric projection screen
Sayfayı Yazdır
Nocturne+ E 220V
Section 2 - Mounting Case with Brackets - Wall Installation
Section 2.1 - Attaching Mounting Brackets
1. Attach mounting brackets to wall using #10 flat head screws installed flush with bracket.
Be sure to use AT LEAST 2 of top mounting holes
Section 2.2 - Attaching Case to Mounting Brackets
1. Attach Case to brackets and tighten Set Screws
2. Proceed to Section 4
(Installing Cable Guides)
1
Figure 3
Section 3 - Mounting Case Directly to Ceiling or Wall
1. Attach Mounting Brackets to Case as a spacer between Case and wall.
Please Note: Leave a 1¾"
(44mm)
, and tighten set screws.
(Fig. 4)
2. Remove roller assembly.
A. Remove screws from bottom of Case, remove Cover and set aside
B. Remove Quick Release Pin from Idler End of Roller Assembly.
C. Remove Roller Assembly, Idler End first, and set aside.
3. Mount to Ceiling / Wall.
A. Using mounting holes in endcaps as a guide
both ends of Case.
B. Attach to mounting surface using appropriate fasteners.
Please Note: Installer is responsible for selecting mounting hardware
appropriate for site conditions.
4. Once Case is secured to mounting surface, re-install Roller Assembly,
Quick Release Pin and Cover.
5. Proceed to Section 4
.
(Installing Cable Guides)
Remove
A
cover.
B
Remove quick
release pin.
.
(Fig. 2)
.
(Fig. 3)
.
2
gap between Endcap and Mounting Bracket
, drill pilot holes on
(Fig. 6)
Figure 5
C
Remove roller
assembly.
Remove screws from
bottom of case.
3
Tighten
set screws.
Figure 4
.
(Fig. 5)
Leave a 1 "
gap.
(44mm)
page 3 of 12
Figure 2
Attach
mounting bracket
as spacer and
tighten set screws.
Figure 6
CEILING
CEILING
MOUNT HOLES
MOUNT HOLES
WALL
WALL
MOUNT HOLES
MOUNT HOLES