Bosch WAA24160GB Çalıştırma ve Kurulum Talimatları - Sayfa 14
Yıkayıcı Bosch WAA24160GB için çevrimiçi göz atın veya pdf Çalıştırma ve Kurulum Talimatları indirin. Bosch WAA24160GB 16 sayfaları.
Sayfayı YazdırMinor faults with simple solutions
!
Repairs necessary in the electrical appliances will only be able to be performed by electricians or
specialist technicians. Repairs carried out incorrectly may be highly dangerous or seriously harm
the user.
Malfunction
The function indicator does not come
on
Electrical power failure
The wash cycle does not start
Water is not visible in the drum
Washing result is unsatisfactory
Foamcomes out of the detergent dra
wer
Foam is visible after the final rinse
Strange motor noises
Pump noises
The machine vibrates when washing
or spinning
The appliance does not spin or does
not empty the water used
The door will not open
Water does not enter the washing
machine
All indicators flash
14 en
Possible cause / Remedy
The machine's plug is not connected or not properly connected
to the socket. The fuse has blown. Electrical power failure.
In the event of a power failure or appliance malfunction,
emergency draining is possible, so that the laundry can be
removed from the machine; see «Cleaning the drainage pump»
Start M
The «
» button has not been pressed. The door is not pro
ready-wash
perly closed («
This is not a malfunction. There is water in the appliance but it is
beneath the visible area. The electronic control reduces con
sumption mantaining all the features.
Abnormally high degree of soiling. Insufficient detergent. Measu
re out the detergent in line with the manufacturer's instructions.
Select the most suitable wash programme for the laundry.
Too much detergent has been used. Disconnect the appliance for
5 10 minutes. To prevent the build-up of foam, put a dessert
spoon of softener mixed with half a litre of water in the detergent
drawer. Reduce the amount of detergent used in your next wash.
Some detergents produce a large quantity of foam although this
has no effect on the rinsing result.
This is not a malfunction. During the heating stage, the motor pro
duces noises characteristic of starting.
This is not a malfunction. These noises are characteristic of the
machine starting and the pump discharging.
The transport securing devices have not been removed. Note the
installation instructions. The adjustable feet on the machine were
not fixed during installation. Place the machine and fix the feet ac
cording to the installation instructions.
The outlet pump is blocked, see «Cleaning the drainage pump»; the
outlet pipe is bent or blocked («
flash in both cases).
The safety feature is activated. The option «
been selected.
The tap is turned off. The water inlet filters are dirty («
wash
spin-end
» and «
the water inlet».
Security protection activated. Close the inlet tap and contact the
After Sales Service.
rinse
» and «
» indicators flash).
rinse
spin-end
» and «
Rinse Hold L
» indicators flash); see «Cleaning the filters in
» indicators
» has
ready-