Bosch WAE20464IL Series Kullanım Kılavuzu ve Kurulum Talimatları - Sayfa 20
Yıkayıcı Bosch WAE20464IL Series için çevrimiçi göz atın veya pdf Kullanım Kılavuzu ve Kurulum Talimatları indirin. Bosch WAE20464IL Series 40 sayfaları.
Sayfayı Yazdır
Operating the appliance
en
The childproof lock can remain
Note:
activated until you wish to start the next
programme, even after switching off the
machine.
You must then deactivate the childproof
lock before starting the programme and
activate it again as necessary once the
programme has started.
Adding laundry
After starting the programme, you can
add or remove laundry as required.
To do this, press the Start/Reload
button.
The Start/Reload indicator light flashes
and the machine checks whether it is
possible to add laundry.
Do not leave the washing
Note:
machine door open for too long when
adding laundry as water from the
laundry may leak out.
If, in the display panel:
Both the YES and ¼ symbols light
■
up, it is possible to add laundry.
NO flashes, wait until the YES and ¼
■
light up.
Do not open the washing machine
door until both the YES and ¼
symbols are lit.
NO lights up, it is not possible to add
■
laundry.
For safety reasons, the washing
machine door remains locked when
the water level or temperature is
high, or while the drum is rotating,
and it is not possible to add laundry
during this time.
To continue the programme, press
the Start/Reload button. The
programme continues automatically.
20
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
Select the other programme.
1.
Press the Start/Reload button. The
2.
new programme starts from the
beginning.
Cancel the programme
For programmes at high temperatures:
Cool down laundry: Select Rinse.
1.
Press the Start/Reload button.
2.
For programmes at low temperatures:
Press Start/Reload.
1.
Select Spin or Empty.
2.
Press the Start/Reload button.
3.
Programme end during rinse
hold
$ (without final spin) appears in the
display panel and the Start/Reload
button indicator light flashes.
To end the programme, set the
programme selector to Rinse/Empty or
select a spin speed. Then press the
Start/Reload button.
Programme end
-0- appears on the display panel and
the "Start/Reload" button indicator lamp
flashes.
If the N symbol also appears on the
display panel, the washing machine has
detected too much foam during the
wash programme and automatically
switched on a rinse cycle to remove the
foam.
Add less detergent for the next
Note:
washing cycle with the same load.