Bosch wae28462gb Kullanım Kılavuzu ve Kurulum Talimatları - Sayfa 26

Yıkayıcı Bosch wae28462gb için çevrimiçi göz atın veya pdf Kullanım Kılavuzu ve Kurulum Talimatları indirin. Bosch wae28462gb 36 sayfaları.

Sayfayı Yazdır

Faults and what to do about them.

Faults

The programme is taking

longer than usual.

The length of the pro-

gramme changes during

the washing cycle.

There is residual water in

the care product compart-

ment.

There are odours or

greasy deposits in the

washing machine.

The N symbol is flashing

on the display panel.

Foam may be leaking

from the detergent

drawer.

Loud noises, vibrations

and machine "movement"

during the spin cycle.

Noises during spin and

drain cycles.

The display panel/indica-

tor lamps do not work

while the appliance is run-

ning.

There is detergent resi-

due on the laundry.

NO appears on the dis-

play panel in Pause mode.

The YES symbol appears

in the display panel in

Pause mode.

If you cannot rectify a fault yourself (after switching the machine off and on again) or a repair is required:

Set the programme selector to the Off position. The appliance is switched off.

■

Unplug the mains plug from the socket.

■

Turn off the tap and call the after-sales service.~ Page 27

■

Cause/remedy

Not a fault – the unbalanced load detection system is adjusting an imbal-

■

ance by repeatedly distributing the laundry.

Not a fault – the foam detection system is activated – a rinse cycle has

■

been switched on.

Not a fault – the programme sequence is optimised for the specific washing

■

process. This may change the length of the programme shown in the dis-

play panel.

Not a fault – the effectiveness of the care product is not affected.

■

If necessary, clean the insert and detergent drawer. ~ Page 21

■

Run the Cottons 90 °C programme without any laundry. Use standard

■

detergent for this.

Have you used too much detergent? Mix one tablespoon of fabric softener

■

with 1/2 litre of water and pour into compartment II (not for outdoor fabrics

or those made with down). Use less detergent in the next washing cycle.

Is the appliance aligned? Align the appliance? ~ Page 33

■

Are the appliance feet secured? Secure the appliance's feet. ~ Page 33

■

Have the transportation safety devices been removed? Remove the trans-

■

portation safety devices.

Clean the detergent solution pump ~ Page 22

■

Has there been a power cut?

■

Have the fuses blown? Switch on/replace the fuses.

■

If the fault occurs repeatedly, call the after-sales service. ~ Page 27

■

Some phosphate-free detergents contain water-insoluble residue.

■

Select the Rinse programme or brush the laundry after washing.

■

The water level is too high. It is not possible to add laundry. Close the wash-

■

ing machine door immediately, if necessary.

Press the Start button to continue the programme.

■

The washing machine door is unlocked. It is possible to add laundry.

■