Draper 83689 Talimatlar Kılavuzu - Sayfa 13

Elektrikli Alet Draper 83689 için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Draper 83689 20 sayfaları. 18v cordless impact wrench

PREPARING THE IMPACT WRENCH

8.1 BATTERY CHARGING FIGS. 1 - 3

This product is supplied with an automatic battery

charger solely designed for charging the batteries

supplied with this machine.

DEFINITION:

Automatic Battery Charger:

Once connected to the mains supply recharging of

the battery can be left generally unsupervised

requiring minimal attention. Complex circuit

construction monitors the battery condition

adjusting the recharge current to suit. When the

recharge cycle is complete and to maintain the full

capacity a low output current will continue as

required.

WARNING: Check the condition of the charger and

battery prior to each charge. If there is any sign of

damage then do not commence charging, seek

advice from Draper Tools.

To charge the battery pack, it must first be removed

from the tool. To release the battery pack, press the

battery release buttons

battery pack off (Fig.1). Plug the battery charger

unit into a 230V/AC 13amp, three pin socket. The

green LED

will stay lit to show the charger has

power.

Slide the battery into place ensuring the battery

terminals and the charger terminals make a good

connection Fig.2. After a few seconds delay the LED

will light red to show the battery is being

charged.

WARNING: Ensure battery is connected correctly.

(Fig 3). Sliding the battery on incorrectly may cause

damage to the battery/charger.

When the battery is fully charged, the green LED

will light.

and gently slide the

FIG.2

FIG.3

FIG.1