Draper TP108VLI Talimatlar Kılavuzu - Sayfa 13

Matkap Draper TP108VLI için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Draper TP108VLI 20 sayfaları. Twin pack 10.8v li-ion cordless rotary drill & impact driver

Sayfayı Yazdır

BASIC CORDLESS ROTARY DRILL OPERATIONS

8.7 TORQUE SELECTION CONTROL - FIG. 6

By turning the collar

amount of torque. The

torque. Use this setting when drilling wood, metal and

plastic.

Settings 1-20 provide a facility for setting the torque to

the required level. For example, this means that repetitive

driving of screws of the same size will be driven into the

material to the same torque, thus giving the same fixing

strength, or in the case of countersunk screws, these will

all be driven to the same depth in the material.

The torque control prevents the heads of small diameter

screws being twisted off when correctly set.

8.8 TWO SPEED GEAR BOX

Select a low gear (1) (slower rotational speed and higher

torque) for screwdriving.

Use a high gear (2) (faster rotational speed and lower

torque) for drilling holes.

8.9 HOLDING THE DRILL - FIGS. 8 - 9

The drill casing is designed to be held comfortably in two

ways,

1. By the handle.

2. Or by the in-line support grip.

8.10 DRILLING WOOD AND PLASTIC

To prevent splitting around the drill holes on the reverse

side, place a piece of scrap timber under the material to

be drilled.

8.11 DRILLING METAL

Metals such as sheet steel, aluminium and brass may be

drilled. Mark the point to be drilled with a centre punch

to help the drill bit tip to locate. A drop of oil on the area

will aid cutting and help prolong the life of the bit.

8.12 SCREWDRIVING

To prevent slip or damage to the screw head, match the

screwdriver bit to the screw head size. To remove screws,

move the direction switch to the reversing position and

apply pressure to the screw head and depress the trigger

slowly).

Screwdriver bits are a consumable item.

Before drilling check that there are no hidden hazards

such as electrical cables, water or gas pipes running below

the surface by use of a metal/voltage detector.

Do not expose either the drill or charger to rain or water.

Do not overcharge the battery (more than six hours) as

this could damage the battery cells.

it is possible to adjust the

logo represents maximum

- FIG. 7

FIG.6

FIG.7

FIG.8

FIG.9