Draper 17135 Talimatlar Kılavuzu - Sayfa 8
Testere Draper 17135 için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Draper 17135 20 sayfaları. 10.8v cordless ratchet - bare
Ayrıca Draper 17135 için: Talimatlar İçin (20 sayfalar)
Sayfayı Yazdır
5.
HEALTH & SAFETY INFORMATION
5.4 INSTRUCTIONS FOR CHARGERS
AND BATTERIES.
1)
Battery Chargers
a)
Before charging, read the instructions.
b)
For indoor use. Do not expose to rain.
c)
Do not charge non-rechargeable batteries.
2)
Battery
a)
The battery must be removed from the appliance
before it is scrapped.
b)
The appliance must be disconnected from the
supply mains when removing the battery.
c)
The battery is to be disposed of safely.
d)
Do not use non-rechargeable batteries.
e)
Do not crush, open or burn the battery. Exposure
to potentially harmful materials may occur.
f)
In case of fire use CO2 dry chemical extinguisher.
g)
Do not expose to high temperatures >50°C. Cells
may degrade at high temperatures.
5.5 ADDITIONAL SAFETY INSTRUCTIONS FOR RATCHET TOOLS
Important: Draper Tools Limited recommends that this machine should not be modified or
used for any application other than that for which it was designed. If you are unsure of its
relative applications do not hesitate to contact us in writing and we will advise you.
–
Power tools shall not be used in potentially explosive atmospheres unless specifically
designed for that purpose;
–
Unexpected tool movement due to reaction forces or breakage of inserted tool or
reaction bar may cause injuries;
–
Power tools shall be isolated from the energy source before changing or adjusting the
inserted tool;
–
Warning:
•
There is a risk of crushing by torque between a reaction bar and the workpiece;
•
There is a risk of loose clothing, hair etc., being caught in the rotating spindle of the
power supply tool;
•
There is a risk of being injured if hands are not kept away from the reaction bar,
specially observed when unscrewing in confined work spaces;
•
There is a risk of being injured if hands are not kept away from the nutrunner sockets;
•
There is a risk of danger to persons from high speed splinters being emitted from
ratchets in the case of nutrunner socket failure.
–
Unexpected direction of inserted tool movement can cause a hazardous situation;
–
Use only sockets and adaptors which are in good condition and are intended for use with
power tools;
–
Adopt a suitable posture to counteract normal or unexpected movement of the power
tool due to reaction forces from the power assembly tool;
–
Release the start and stop device in the case of an interruption of the energy supply;
8
h)
The battery must be charged by a constant
current, constant voltage transformer.
i)
Charge battery regularly in conditions between
5°C to 45°C with the specified charger designed
for this battery.
j)
Store in a dry, well ventilated area within the
recommended limits of 15°C to 30°C.
k)
Do not use battery if it has been stored at 5°C or
less. Allow it to "normalise" at room temperature
before usage/changing.
l)
During decommissioning remove the battery cell
for recycling separately to the product, which is
covered by the waste electrical and electronic
equipment directive. Insulate the terminals with
adhesive insulating tape to prevent a short circuit,
fire or explosion occurring.