Draper BS190 Talimatlar Kılavuzu - Sayfa 6
Testere Draper BS190 için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Draper BS190 20 sayfaları. Two wheel bandsaw
Ayrıca Draper BS190 için: Kullanım Kılavuzu (20 sayfalar)
Sayfayı Yazdır
ADDITIONAL SAFETY RULES FOR BANDSAWS
1. Lower the blade guard to within approximately
1
3mm (
⁄
") above the material being cut.
8
2. Always keep hands and fingers away from the
saw blade, especially when coming to the end
of a cut.
3. Use a push stick or piece of scrap wood to do
the pushing and guiding when sawing small
pieces which require the fingers to be close to
the saw.
4. Switch the machine off and let the blade come
to a stop before removing scrap pieces from
the table.
6. Make all adjustments and set ups with the
power off and plug removed from the power
supply, such as tilting the table, adjusting the
saw blade guards and blade guides.
7. Disconnect the machine before adjusting the
blade tension and the blade tracking.
8. The cover housing must be in place and
securely fastened when performing any
operation.
9. Securely lock all adjustable parts so they
cannot loosen. This will prevent distraction
from the operation.
10. When sawing curves, make relief cuts to allow
removal of scrap material. This will help
prevent undue twisting or binding of the saw
blade. The relief cuts are made before starting
the curved saw cut.
11. Hold material firmly and feed into the blade at
a moderate speed.
12. Be sure to use the correct blade size and type
for the application.
13. Do not saw any material that does not have a
flat surface, unless a suitable support is used.
14. Permanently fix your bandsaw to a bench
before performing cutting operations. (See
'Fastening to a Workbench', page 12).
15. Use in a well ventilated area to minimise
airborne dust.
16. Before freeing any jammed material turn
switch off, disconnect from power supply and
wait for all moving parts to stop.
17. Before starting to cut, watch the saw while it
runs. If it makes an unfamiliar noise or vibrates
excessively, stop immediately. Turn the saw off
and disconnect from the power supply. Do not
attempt to use the saw until the problem has
been rectified.
18. Repair or servicing required on this product
should be made only by a qualified person.
When servicing use only identical
replacement parts.
19. Do not use saw bands which are damaged or
deformed.
20. Replace table insert when worn.
21. When cutting round timber use a suitable
device to prevent twisting of the workpiece.
22. When bevel cutting with the table inclined,
place the guide on the lower part of the table .
23. Connect bandsaws to a dust collecting device
when operating.
24. Do not operate the machine when the door or
guard protecting the band is not closed.
- 6 -