Draper 02519 Manuel - Sayfa 13

Öğütücü Draper 02519 için çevrimiçi göz atın veya pdf Manuel indirin. Draper 02519 20 sayfaları. 230v router
Ayrıca Draper 02519 için: Manuel (20 sayfalar)

Sayfayı Yazdır

PREPARING THE ROUTER

8.4

PROTECTIVE SAFETY SCREEN –

FIG. 3

If not already in place, slot the screen (14) into the

recess and fasten, using the screw provided.

8.5

FITTING & REPLACING ROUTER

BITS – FIG. 4

Stock No.02519 is designed for use with 6mm,

•

8mm and 1 ⁄ 4" shank router bits only.

Stock No.02520 is designed for use with 1 ⁄ 4",

•

1 ⁄ 2", and 12mm shank router bits only.

Warning! Use bits of the correct shank diameter

suitable for the speed of the tool.

Selection of the correct router bit, suitable for the

intended application is vital. Seek guidance if

uncertain of selection.

Press the spindle lock button (13) and unscrew the

collet nut (10) using the spanner (15) supplied.

Note: Take care not to loose the spring behind the

collet.

From the collets provided, choose the appropriate

size for the cutters shank. If the size is not known

insert the bit into the collet. The collet which offers

a machine fit to the shank is the correct one to

use. Do not force the bit into a collet.

Replace the spring and place the collet into the

spindle before loosely replacing the nut (10).

Slide in the bit allowing approx. 5-10mm overhang

before tighten the collet nut (observe the router

bit's manufacturers instructions for more specific

information).

Note: Ensure at least 75% of the shank is inside

the collet. Do not tighten the collet with no bit fitted

as this will cause damage.

Do not over-tighten the collet nut.

Warning! Take care when handling the cutter bits

as they are extremely sharp.

When cutting is complete remove the bit before

cleaning and storing it in a safe place.

(14)

FIG.

(10)

FIG.

– 13 –

(13)

(15)