Draper 29621 Talimatlar Kılavuzu - Sayfa 8

Öğütücü Draper 29621 için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Draper 29621 16 sayfaları. Bench grinders
Ayrıca Draper 29621 için: Talimatlar Kılavuzu (16 sayfalar)

Sayfayı Yazdır

To correctly assemble, fit and adjust the tool

rests, spark deflectors and eye shields.

Carefully follow these instructions:

TOOL RESTS.

Attach the left and right hand tool rests ✪✌

using the four bolts ✫✌ and large washers ✬✌

as shown in Fig.3. Now adjust the tool rests so

there is approximately a 1.5mm (

between the surface of the grinding wheels

and the tool rests.

SPARK DEFLECTORS

Attach the two spark deflectors ✭✌ using the

two bolts ✮✌ and medium size washers ✯✌ as

shown in Fig.4. Now adjust the spark deflectors

so there is approximately a 1.5mm (

between the surface of the grinding wheels

and spark deflectors.

EYE SHIELDS

Place the eye shield frame ✰✌

over the eye shield ✱✌ fasten the

two parts together using the long

screws ✲✌, washers ✳✌ and nuts

✴✌. See Fig. 5.

Note: Do not overtighten as the

eye shield may crack.

Assemble the other eyeshield in

the same way.

Insert the shortest end of the

mounting rod ✵✌ Fig.6 into the

hole ✶✌ in the shield frame ✷✌.

Now tighten the nut ✸✌ and round

headed bolt which are located in

the centre of each of the eye shield

mounting frames ✹✌. Fig.7 shows

the assembled eye shield

assembly.

ASSEMBLY

⁄

") gap

⁄

") gap

Fig.6.

Fig.4.

Fig.5.

✷✌

✵✌

✶✌

- 7 -

✫✌

✮✌

✱✌

✴✌

Fig.7.

✸✌

Fig.3.

✪✌

✬✌

✭✌

✯✌

✰✌

✳✌

✲✌

✹✌