Draper FlexShade Talimatlar Kurulum ve Çalıştırma - Sayfa 10

İç Mekan Mobilyaları Draper FlexShade için çevrimiçi göz atın veya pdf Talimatlar Kurulum ve Çalıştırma indirin. Draper FlexShade 16 sayfaları. Exterior clutch-operated shade
Ayrıca Draper FlexShade için: Kurulum ve Kullanım Kılavuzu (8 sayfalar), Kurulum Talimatları (2 sayfalar), Talimatlar Kılavuzu (12 sayfalar), Kurulum ve Çalıştırma Talimatları (11 sayfalar), Talimatlar Kurulum ve Çalıştırma (12 sayfalar), Talimatlar Kurulum ve Çalıştırma (16 sayfalar), Talimatlar Kurulum ve Çalıştırma (4 sayfalar), Talimatlar Kılavuzu (7 sayfalar), Talimatlar Kurulum ve Çalıştırma (12 sayfalar)

Sayfayı Yazdır

FlexShade

Section 8 - Mounting Headbox and Side Channels in Recessed Pockets

(Alternate Hardware & Installation Method)

Please Note: 2" U Channel Adaptor option MUST be ordered for the channel to be included with unit —

it is not provided standard. Shade MUST be ordered 5/ 8 " narrower as well.

Please Note: Be sure to provide adequate clearance for removal of Roller Assembly during installation and maintenance.

Minimum depth of ceiling pocket is 7 9/ 1 6

NOTE:

Installer MUST provide a recessed pocket

at the top of the channel large enough

to allow for headbox installation and

accommodate hem bar and fascia install/

removal.

(Section ??)

E N

C A

Insert provided 'U' Channel into recessed cavity

in building structure. Drill mounting holes and

secure, using appropriate hardware

Please Note: Installer is responsible

for selecting mounting hardware

appropriate for site conditions.

Please Note: Specific Fastener

locations determined by installer.

Max. spacing between fasteners:

24"

(610mm)

C H A

W A L

Crank-Operated ZIP

Use a 3 mm Hex Wrench to remove Screws

from Side Channels and Side Channel Covers.

Please Note: Do NOT remove the

Bottom Caps from Side Channels.

(by others)

'C' Channel

Mounting Hardware

(by Others)

Speciﬁc Fasterner locations

determined by installer

' U '

N N E

W A L

or sufficient to conceal hem bar.

(159mm)

Please Note: Make note

of left & right covers,

to match up correctly

when re-attaching.

t o

T i n

C U

R E

U A

S Q

Foam

Padding

C054. 218

Remove Fabric Retainer

Strips from Side Channels.

Please Note: Make note of left & right

Fabric Retainer Strips, to match up

correctly when re-attaching.

Cut foam strips

into 1.5"

(provided)

squares and

(38mm)

attach them to the 'U'

Channel at all desired

mounting points of the

Side Channel.

' U '

C H A

N N E

W A L

page 10 of 16

U P

W A L