Draper FlexShade 2 Pocket Headbox Talimatlar Kılavuzu - Sayfa 4

İç Mekan Mobilyaları Draper FlexShade 2 Pocket Headbox için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Draper FlexShade 2 Pocket Headbox 8 sayfaları. Maximized coverage for large, tall areas, while also reducing light gap

Sayfayı Yazdır

FlexShade

Section 2 - Removing/Replacing Roller

If there is not sufficient access above the ceiling to access the end plates, use

the knockouts located in the top of the case just below the mounting bracket

holes. To access knockouts, remove the hole covers and remove the shade

motor/roller assembly.

Removing Shade/Motor Assembly

1. Unplug motor from unit wiring

2. Remove cotter pin from idler assembly.

3. Remove locking screw from motor retainer spring, then expand motor

retianer spring around the motor-end bracket

4. The idler is spring-loaded. Push motor/roller assembly toward the

idler end. Remove motor from motor mount, then remove idler end.

Set roller assembly aside.

5. Mount the case in the pocket using tabs on the end plates. Use a

long-handled screwdriver to access the bracket mounting holes

through the knockouts.

Section 3 - Replacing Shade/Motor Assembly

Figure 2

Screw and

Retaining

Spring

Please note: Maximum torque for

tightening screw is 5 lb-in

(22.24 Nm)

Figure 3

2 Pocket Headbox

(Fig. 1)

(Fig. 2)

1. Ensure motor retainer ring is expanded around the motor end bracket

2. Place motor/roller assembly in the idler end. Push spring-loaded idler into idler mount

3. Ensure that motor retainer ring is properly installed around the grooves in the motor and motor

4. Install the motor retainer ring screw and tighten

Please note: Maximum torque for tightening screw is 5 lb-in

5. Use the provided spanner wrench to rotate the idler until the holes in the idler match up with the

6. Using a pair of needle-nosed pliers install the cotter pin

Figure 1

INTERNAL WIRING

then move motor end into motor mounting bracket.

end bracket

(Fig. 2)

vertical holes in the idler mounting bracket as seen when looking straight up into the case

to prevent pin from falling out.

Figure 4

Shade roller removed for clarity

PLUG

(Fig. 2)

(22.24 Nm)

. The pin has a built-in ball detent

(Fig. 5)

Figure 5

Cotter

page 4 of 8

(Fig. 3)

(Fig. 4)