Draper Storm Force MT400 SF Talimatlar İçin - Sayfa 11
Sander Draper Storm Force MT400 SF için çevrimiçi göz atın veya pdf Talimatlar İçin indirin. Draper Storm Force MT400 SF 16 sayfaları. 400w 230v oscillating multi-tool kit
Ayrıca Draper Storm Force MT400 SF için: Kullanım Kılavuzu (20 sayfalar)
Sayfayı Yazdır
9.
OPERATING THE POLISHER
9.1
OPERATING THE POLISHER
SWITCH - FIG. 5
To start the polisher, pull the trigger
hold. For prolonged operation, it is possible to
lock the trigger in the ON position. Pull trigger
and hold to start the polisher and push
button
. Release trigger
release button
the ON position. To release the lock, pull
trigger
and release.
9.2
STEPPED SPEED SETTING -
FIG. 6
Set the stepped speed in accordance to the
cutting paste/compound or polish being used.
Read the manufacturers instructions regarding
this. No responsibility or liability is accepted by
Draper Tools regarding the setting of the
correct speed for the job to be done. The
speed settings are approximately as per table
below.
Speed setting
1
2
3
4
5
6
NOTE: We strongly recommend that the
polisher, speed setting, the polishing
sponge/mop and medium being used are
tested on a small, inobscure area before
applying to a vehicle panel or similar.
IMPORTANT: Excessive pressure on the
machine does not result in higher working
speed. It increases wear on the internal
mechanics and can damage the polisher.
and then
.This will lock the trigger in
Corresponding RPM
(approx.)
600
1100
1600
2100
2600
3300
FIG. 5
and
FIG. 6
11