Bosch WIA24201GC Kullanım Kılavuzu ve Kurulum Talimatları - Sayfa 22
Yıkayıcı Bosch WIA24201GC için çevrimiçi göz atın veya pdf Kullanım Kılavuzu ve Kurulum Talimatları indirin. Bosch WIA24201GC 32 sayfaları. Fully integrated built-in washing machine with time-delay function
Sayfayı Yazdır
Grey residues on the
washing.
Programme terminated
unexpectedly.
The fabric softener is not
completely flushed in or too
much water remains in the
compartment i.
No response from the
indicator lamps.
Washing machine door
cannot be opened.
Emergency release
If you cannot correct a fault yourself (switching on/off) or a repair is required:
– Turn the programme selector to Off and disconnect the mains plug from the socket.
– Turn off the tap and call the after-sales service page 23.
Soiling caused by ointments, grease or
oil
Detergent dosage too low.
The Start/Pause button has been
pressed accidentally.
The fabric softener compartment insert
is not correctly attached or is blocked.
Power cut.
(Rinse stop) selected.
2
The programme is running or the door
is locked for safety reasons.
Power cut.
To release the door mechanically in the event of a power cut:
Turn the programme selector to Off and unplug the mains plug from the
socket.
Open the base panel and drain out the water page 18.
Pull the emergency release downwards and open the door at the same time.
– Before opening the door, make sure that there is no water or hot
detergent solution in the washing machine.
Under no circumstances must you open the door with the emergency release
while the drum is still turning.
Wash the laundry using the maximum
detergent dosage and the maximum
permissible temperature – see the
care label.
Press the button again to restart the
programme.
Clean the fabric softener compartment
insert and fit it correctly in the
compartment i page 17.
The programme continues when power
is restored. If you wish to
remove the laundry during a power cut,
you must first drain out the water
page 18. Check whether:
-the plug is plugged into the socket
correctly
-the circuit breaker (fuse) has tripped;
call the after-sales service. .
Select the programme Empty
press Start/Pause.
Wait until "Ÿš appears on the display
panel.
Unlock the washing machine door
mechanically.
[
and
22