Bosch WLK20261BY Kullanım Kılavuzu - Sayfa 34
Yıkayıcı Bosch WLK20261BY için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Bosch WLK20261BY 38 sayfaları.
Sayfayı Yazdır
Positioning and connecting
en
Notes
The lock nuts on all four appliance
■
feet must be screwed tightly against
the housing.
Incorrect levelling may result in
■
intense noise, vibrations and
"wandering".
Electrical connection
:
Warning
Danger of death!
There is a risk of electric shock if you
touch live components.
Never touch or hold the mains plug
■
with wet hands.
Only pull out the mains cable by the
■
plug and never by the cable, as this
could damage it.
Never unplug the mains plug during
■
operation.
Observe the following information and
ensure that:
Notes
The mains voltage and voltage
■
indicated on the washing machine
(rating plate) are the same.
The connected load and fuse
required are specified on the rating
plate.
The washing machine is only
■
connected to an alternating current
via a properly installed earthed
socket.
The mains plug fits the socket.
■
The cable cross-section is adequate.
■
The earthing system is properly
■
installed.
The mains cable is only replaced by
■
a qualified electrician (if this is
necessary). Replacement mains
cables are available from the after-
sales service.
No multiple plugs/couplings or
■
extension cables are used.
34
If an earth-leakage circuit breaker is
■
used, only a type which displays this
symbol is used: z.
Only this symbol guarantees
compliance with the currently
applicable regulations.
The mains plug can be accessed at
■
all times.
The mains cable is not bent,
■
squashed, modified, cut through, or
in contact with heat sources.
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. In
order to remove any water which may
be left over from the test, run the first
washing cycle without any laundry.
Notes
The washing machine must be
■
correctly installed and connected.
Installation and
connection~ Page 29
Never use a damaged washing
■
machine. Inform your customer
service. ~ Page 26
Check the washing machine.
1.
Insert mains plug.
2.
Turn the tap on.
3.
Switch on the appliance.
4.
Close the washing machine door (do
5.
not load any laundry).
Select the i ü Cottons
6.
programme.
Select the temperature 90 °C.
7.
Open the detergent drawer.
8.
Pour approx. 1 litre of water into
9.
dispenser II.
Add standard detergent to
10.
dispenser II according
to manufacturer's instructions for
light soiling.
To prevent frothing, use only
Note:
half the recommended amount of
detergent. Do not use any woollens
or mild detergents.