Bosch WLX 20461 Kullanım Talimatları Kılavuzu - Sayfa 2
Yıkayıcı Bosch WLX 20461 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Bosch WLX 20461 8 sayfaları.
Sayfayı Yazdır
Safety instructions
- Read and follow the operating and installation instructions and all other information enclosed
with the washing machine.
- Retain documents for subsequent use.
Risk of electric shock
Danger to life
Risk of suffocation
Risk of poisioning
Risk of explosion
Risk of injury
Consumption values
Programme
Cottons y 40 ºC*
Cottons Eco j 60 ºC*
Cottons y 90 ºC
Easy Care A 40 ºC*
Easy Care A 40 ºC*
(also suitable as short
programme)
Mix zx 30 ºC
Delicate/Silk æ 30 ºC
Wool/u U 30 ºC*
* Programme setting to be tested in accordance with European standard 60 456.
Note on comparative tests: test the test programme with maximum load,
additional function selected, maximum spin speed.
A short programme which can be used for coloured items is Easy Care A 40 ºC, without the
v
(Intensive Wash) additional function selected and set to maximum spin speed.
** The values deviate from the indicated values depending on water pressure, water hardness, water
inlet temperature, room temperature, type and amount of washing and degree of soiling, utilised
detergent, fluctuations in the mains voltage and selected additional functions.
Downloaded From WashingMachine-Manual.com Manuals
7
Care
Machine housing, control panel
- Wipe with a soft, damp cloth.
- Do not use any abrasive cloths, sponges or cleaning agents (stainless steel cleaner).
- Never pull out the mains plug by tugging the power cord!
- Immediately remove washing and cleaning agent residue.
- Never insert/pull out the mains plug with damp hands.
- Do not clean the appliance with a water jet.
Redundant appliances:
Clean the detergent drawer ...
- Pull out the mains plug.
- Sever the power cord and discard together with the plug.
... if it contains detergent or fabric softener residue.
- Destroy the lock on the washing machine door.
1.
Pull out, depress insert, completely remove.
This will prevent children from locking themselves in and
suffocating.
- Keep packaging, plastic film and packaging parts out of the reach
of children.
2.
Open the insert.
- Keep detergents and care products out of the reach of children.
- Caused by detergents containing solvents, e.g. stain
remover/items of washing pretreated with solvent naphtha may
3.
Clean with water and dry.
result in an explosion after being loaded into the washing machine.
Before hand thoroughly rinse items of washing by hand.
- Washing machine door may become very hot.
- Caution when draining hot detergent solution.
4.
Close and lock the insert (place cylinder on guide pin).
- Do not climb on the washing machine.
- Do not lean on the open washing machine door.
- Do not touch the drum in case it is still spinning.
5.
Insert detergent drawer.
Leave detergent drawer open so that residual water can evaporate.
Additonal
Load
Current**
Water**
Programme
Drum
function
duration**
Leave washing machine door open so that the drum can dry out.
v
4,5 kg
0,55 kWh
50 l
2:11 h
(Intensive Wash)
Rust stains use chlorine free cleaning agent, not steel wool.
v
(Intensive Wash)
4,5 kg
0,76 kWh
40 l
2:15 h
Descaling
No washing in the machine!
v
(Intensive Wash)
4,5 kg
1,40 kWh
59 l
2:11 h
Not necessary if detergent dispensed correctly. However, follow the instructions of the descaler
v
(Intensive Wash)
2,5 kg
0,45 kWh
50 l
1:31 h
manufacturer.
-
2,5 kg
0,45 kWh
40 l
0:55 h
Information on the display panel
-
2,0 kg
0,60 kWh
30 l
0:44 h
-
2,0 kg
0,20 kWh
36 l
0:32 h
F: 16
Close the washing machine door properly; laundry may be caught.
-
2,0 kg
0,13 kWh
30 l
0:40 h
F: 17
Turn the tap on fully; supply hose kinked/trapped;
Clean the filter -> Page 9; water pressure too low.
F: 18
Detergent solution pump blocked; Clean the detergent solution pump -> Page 10.
v
(Intensive Wash)
Drainage hose / waste pipe blocked; Clean the drainage hose at the siphon ->
Page 10.
F: 21
Motor fault. Call customer services.
F: 23
Water in the base tub, appliance leaking. Call customer services.
8
Risk of electric shock!
Risk of scalding!
Maintenance
Pull out the mains plug!
Allow deterhgent solution to cool down!
Risk of explosion! No solvents!
Turn off the tap!
Detergent solution pump
Set programme selector to Off, pull out the mains plug.
1.
Open and remove service flap.
2.
Carefully unscrew pump cover until the detergent
solution begins to run out. When the service flap is half
full, screw back the pump cover and empty the service
flap. Repeat steps until all the detergent solution has run
out.
3.
Carefully unscrew the pump cover (residual water).
4.
Clean the interior, pump cover thread and pump housing (fan impeller in the
detergent solution pump must rotate).
5.
Reinsert and screw on pump cover.
6.
Insert and close service flap.
To prevent unused detergent from flowing into the outlet during the next wash:
Pour 1 litre of water into dispenser II and start the Empty
b
Drainage hose at the siphon
Set the programme selector to Off, disconnect the mains plug.
1.
Loosen the hose clamp, carefully remove the drainage hose (residual water).
2.
Clean the drainage hose and siphon connecting piece.
3.
Reattach the drainage hose and secure the connection with the hose clamp.
Filter in the water inlet hose
Risk of electric shock!
Do not immerse Aqua Stop safety device in water
(contains electric valve).
Release water pressure in the supply hose:
1.
Turn off the tap!
B
b
2.
Select any programme (except Spin
/Empty
).
depending on model
3.
Select
M
(Start/Pause). Leave programme for approx. 40 seconds.
4.
Set programme selector to Off. Pull out the mains plug.
Clean filter:
1.
Depending on model:
- Remove hose from tap.
Clean filter with small brush.
or
- Remove hose from the rear.
Remove filter with pliers and clean.
2.
Connect the hose and check for leaks.
9
What to do if ...
F
Water is running out.
- Correctly attach/replace drainage hose.
- Tighten screw fitting on the supply hose.
F
Water not flowing in.
-
M
(Start/Pause) not selected?
Detergent not washed
- Tap not open?
in.
- Filter blocked? Clean filter -> Page 10.
- Supply hose kinked or jammed?
F
Washing machine door
- Safety function active. Wait approx. 2 minutes.
cannot be opened.
- L (Rinse stop = without final spin) selected? -> Page 4.
F
Programme does not
-
M
(Start/Pause or
Á
(Ready in) selected?
start.
- Washing machine door closed?
F
Detergent solution is not
- Clean detergent solution pump -> Page 10.
drained.
- Clean outlet pipe and/or drainage hose.
F
Water not visible in the
- Not a fault - water below the visible area.
drum.
F
Spin result not
- Wash small and large items of washing together.
satisfactory.
-
e
(Less Ironing) selected? -> Page 5.
- Too low speed selected? -> Page 3.
F
Spin cycle actuated
- Not a fault - unbalanced load detection system adjusts
several times.
imbalance.
2
F
Dispenser
not
- Remove the insert. Clean detergent drawer and insert > Page 9.
programme.
completely rinsed out.
F
Odour formation in the
- Run Cottons y 90 ºC programme without washing. Use
washing machine.
standard detergent.
F
Foam is coming out of
- Too much detergent used?
the detergent drawer.
Mix 1 tablespoon of fabric softener with ½ litre of water and pour
into compartment II (not with outdoor fabrics!).
- Reduce detergent dosage for the next wash cycle.
F
Intense noise formation,
- Appliance feet fixed?
vibrations and
Secure appliance feet > Installation instructions, Page 5.
"wandering" during spin
- Transportation safety devices removed?
cycle.
Remove transportation protection devices > Installation
instructions, Page 3.
F
Display panel/indicator
- Power failure?
lights do not function
- Fuse tripped? Switch on/replace fuse.
while the appliance is
- If the fault occurs repeatedly, call customer service.
running.
F
Programme progress
- Not a fault - unbalanced load detection system adjusts imbalance
longer than usual.
by repeatedly distributing the washing.
- Not a fault foam detection system active - a rinse cycle is
started.
F
Detergent residue on the
- Occasionally phosphate free detergents contain water insoluble
washing.
residue.
- Select Rinse/Freshen Up K or brush the laundry after washing.
F
If a fault cannot be rectified or a repair is required:
- Set programme selector to Off and pull out the mains plug.
- Turn off tap and call customer service > Installation instructions, Page 7.
10
Washing machine
en
Operating instructions
Read these instructions before switching on the washing machine!
Also follow the separate Installation instructions.
Follow the safety instructions on page 11!
11