Drawmer DS301 Operatör El Kitabı - Sayfa 4

Amplifikatör Drawmer DS301 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Drawmer DS301 20 sayfaları. Dual midi expander gate

INSTALLATION

The DS301 is designed for standard 19O rack mounting and occupies 1U of rack

space. Avoid mounting the unit directly above power amplifiers or power supplies

that radiate significant amounts of heat and always connect the mains earth to

the unit. Fibre or plastic washers may be used to prevent the front panel

becoming marked by the mounting bolts.

AUDIO CONNECTIONS

Both the input and output XLRs are balanced, the wiring convention being: pin 1

ground, pin 2 hot and pin 3 cold. The system is optimised for +4dBu operation in

accordance with pro-audio requirements. For use with unbalanced systems, pin

3 on both the input and output XLRs should be grounded.

Side-chain access is made via stereo jacks wired tip-return, ring-send. The return

input may be used on its own for external triggering of the gate. For external key

input it is recommended that a stereo jack is used with its ring terminal

unconnected.

If earth loop problems are encountered, do not disconnect the mains earth but

instead, try disconnecting the signal screen on the cables connecting the DS301

to the patchbay. If such measures are necessary, balanced operation is

recommended.

MIDI CONNECTIONS

Two standard 5 pin MIDI sockets are fitted to the rear panel of the DS301. The

Input socket should be sent MIDI data from a sequencer, a keyboard or a MIDI

controller. This data is always 'echoed' at the MIDI Output socket, rather like a

normal MIDI Thru socket on equipment with three MIDI sockets. The MIDI data

generated by the DS301 is also transmitted from the Output socket, merged into

the MIDI data copied from the Input socket.

-2-