Drawmer CMC7 Manuel - Sayfa 9

Kontrolör Drawmer CMC7 için çevrimiçi göz atın veya pdf Manuel indirin. Drawmer CMC7 12 sayfaları. Surround monitor controller

Sayfayı Yazdır

WARNING:

It is recommended that you turn the volume control down to a lower level before

turning the CMC7 off - this is to ensure that a sudden volume increase when

turning on does not damage your speakers or your hearing.

In addition, do not use excessive force at either end of the volume knob - it's

size would mean that damaging the potentiometer is possible.

OUTPUT

Mute:

Cuts the volume of all channels (especially useful in an emergency). Note

that

Mute

affects the headphones in the same way as it does the speakers.

Dim: With the switch active the output level is attenuated by 20dB's. It enables you

to lower the volume without adjusting any of the settings.

STEREO MIX

Active:

W hen active mixes down all eight channels to their relevant position within

the stereo mix and outputs the signal via the Left and Right speakers and also the

Sub signal to the LFE of the surround setup.

SUB:

Toggles the Sub (LFE) on and off to hear the stereo mix through the L and R

speakers only. Note that this switch only functions when the stereo mix is active.

HEADPHONE LEVEL

The CMC7 has a dedicated headphone output, via 1/4" TRS jack on the rear face

(7), with individual headphone amplifier and level trim

headphone operates in stereo, with all eight channels mixed down to their relevant

position within the stereo mix.

Note that the headphone level control is a trim that works simultaneously with the

Master Volume

(1)

suit all types of headphones, from professional studio grade to consumer. It

responds to Dim and Mute

The headphone output trim has no bearing on the volume of the main speaker

outputs (6), however, as the headphone amplifier is of such a high quality the

headphone output could be used as a source for a second set of stereo monitors,

should they be required, the trim control being used for speaker level matching.

Warning:

It is advisable to unplug the headphones before switching the CMC7 on or off.

It is also recommended that you turn the headphone level down before inserting

the jack, and turn it up to your desired listening level - these measures will not

only prevent your ears from being damaged but also the headphone's drivers.

Also, note that these are high quality circuits and have been designed for

professional headphones, so care must be taken to lower the volume using

the headphone level control when using lower standard, consumer quality

headphones as damage could occur.

to adjust the volume of the headphones so that this output can

(2)

in just the same way as the speaker outputs do.

CMC7

- Surround Monitor Controller

(4)

on the top face. The