Bosch Benchmark HBLP651LUC Servis Kılavuzu - Sayfa 19
Fırın Bosch Benchmark HBLP651LUC için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Bosch Benchmark HBLP651LUC 45 sayfaları. Built-in wall ovens
Ayrıca Bosch Benchmark HBLP651LUC için: Teknik Özellikler (3 sayfalar), Kurulum Kılavuzu (39 sayfalar), Kurulum Kılavuzu (22 sayfalar)
Sayfayı Yazdır
58300000181895 ARA EN A
Figure 17 Removing inner support frame assembly
7. Lift the two pieces of insulation off the inner support frame
assembly and set aside.
8. Remove the screws securing the right and left side door shields
and set shields aside.
9. Carefully lift the glass pack out of the inner support frame.
Figure 18 Removing 2-pane glass pack
10. After removing and discarding all remnants of broken glass, install
the new glass pack assembly and reassemble the door.
11. Test operation of the door by fully opening and closing it several
times.
Copyright by BSH Home Appliances Corporation
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
JUNE 2014
1 Door side shield
2 Inner support frame
3 Two-pane glass pack
1
2
3
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
Service Manual for Bosch Benchmark Series Built-in Wall Ovens
6.2
Side-Hinge Doors
The serviceable parts of the side-hinge door include the handle,
endcaps, outer door glass/skin (service assembly), side hinge
assembly, 2-pane glass pack, middle glass, porcelain-coated door
liner, latch receiver assembly, and the various fasteners.
6.2.1
Removing and Reinstalling the Door
CAUTION
Avoid injury when removing and replacing oven doors.
Be sure oven is cool enough for handling.
Grasp only by sides, not by the handle.
Do not force door open or closed.
Handle with care–the door weighs approximately 40 lb.
To remove the door...
1. Open door fully.
2. Remove 3 Torx T-20 screws securing lower hinge to chassis (A);
do not remove the Phillips-head screw (B) – this controls the
door alignment cam.
Figure 19 Removing lower hinge assembly screws
Page 19 of 45
800 944-2904