Bosch Benchmark Series Servis Kılavuzu - Sayfa 16
Fırın Bosch Benchmark Series için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Bosch Benchmark Series 36 sayfaları. Built-in wall ovens
Ayrıca Bosch Benchmark Series için: Kurulum Kılavuzu (32 sayfalar), Hızlı Referans Kılavuzu (4 sayfalar), Servis Kılavuzu (45 sayfalar), Kurulum Talimatları Kılavuzu (40 sayfalar), Hızlı Başlangıç ve Güvenlik Kılavuzu (13 sayfalar)
Sayfayı Yazdır
58300000187895 ARA EN A
4. Lift the liner away from the rest of the door assembly and set
aside.
5. Remove the screws at the top left and top right which secure
the handle to the door assembly.
6. Carefully lift the inner support frame with glass pack and
hinges away from the outer door glass/skin assembly and lay
flat on the work surface.
Figure 11 Removing inner support frame assembly
7. Lift the two pieces of insulation off the inner support frame
assembly and set aside.
8. Remove the screws securing the right and left side door
shields and set shields aside.
9. Carefully lift the glass pack out of the inner support frame.
Figure 12 Removing 2-pane glass pack
Copyright by BSH Home Appliances Corporation
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
MAY 2015
1 Door side shield
2 Inner support frame
3 Two-pane glass pack
1
2
3
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
Service Manual for Bosch Benchmark Series Induction Slide-in Ranges
10. After removing and discarding all remnants of broken glass,
install the new glass pack assembly and reassemble the door.
11. Test operation of the door by fully opening and closing it
several times.
7.2
Door Latch/Motor Assembly
The motorized door latch (MDL) mechanism (120VAC 60Hz 4.3W)
has 2 switches - the door switch and the lock/unlock switch. The latch
will automatically lock when mode and temperature selectors are set
to Self Clean, and unlock when the oven cools to ~490°F (255°C). The
latch and motor are serviced as an assembly.
Figure 13 Oven door latch
If the latch becomes stuck in the locked position, turning the unit off
and back on will open the latch if the cavity temperature <491°F. If
latch is stuck in a partially locked position, turn the mode and
temperature selectors to Self Clean, then turn them to Off.
If these measures fail, run a thin wire or wire coat hanger in between
the door and the front face of the range. Figure 14 shows where to
position the wire between the latch hook (1) and the plunger (2). Slide
the wire to the left, pushing the latch hook left and releasing the latch.
Page 16 of 36
800 944-2904