Bosch Evolution HES7282U Kurulum Talimatları Kılavuzu - Sayfa 15
Fırın Bosch Evolution HES7282U için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Bosch Evolution HES7282U 48 sayfaları. Electric free-standing range
7) Complete the installation
• A risk of tip-over may exist if the appliance is not installed in accordance with
these instructions.
• If the range is pulled away from the wall for cleaning, service, or any other rea-
son, ensure that the Anti-Tip Device is properly reengaged when the range is
pushed back against the wall. In the event of abnormal usage (such as a person
standing, sitting, or leaning on an open door), failure to take this precaution could
result in tipping of the range. Personal injury might result from spilled hot liquids or
from the range itself.
1. Adjust height of range and level by rotating the adjustable leg supports on the
bottom of the range, using 1-1/4" (31.75 mm) wrench.
2. Measure to locate bracket position as shown below.
cabinet wall
3. Secure bracket with 2 screws adequate for mounting surface, not included.
(i.e.; for wood floor use wood screws for concrete floor use concrete anchors
and screws).
1. Move range close enough to the opening to plug into the receptacle.
2. Slide range into position ensuring that the left back leg slides under the anti-
tip bracket. Range will sit 3/4" (19.05 mm) away from back wall when properly
installed.
3. Carefully tip range forward to ensure that the anti tip bracket engages the
range back brace and prevents tip-over.
4. Turn on electrical power. Check range for proper operation as described in
Use and Care Manual.
drawer
wrench
adjustable leg
Adjusting the Leg Support
Figure 19:
rear wall
1 9/16" (39.7 mm)
from rear wall to center of screw hole
anti-tippin g
device
flush against
cabinet wall
Anti-tip Bracket Location
Figure 20:
floor
English 13