Bosch HB578A0S0B/30 Kullanım Kılavuzu - Sayfa 22
Fırın Bosch HB578A0S0B/30 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Bosch HB578A0S0B/30 48 sayfaları.
Sayfayı Yazdır
Cleaning function
en
Before running the cleaning function
Make sure that the cooking compartment is empty.
Remove any accessories, cookware or shelf rails from
the cooking compartment. Please see the relevant
section for information on how to remove the rails.
~ "Rails" on page 23
Clean the appliance door and along the edges of the
cooking compartment in the area around the seal. Do
not scrub or remove the seal.
:
Warning
Risk of fire!
Loose food remnants, fat and meat juices may catch
■
fire when the cleaning function is in progress. Before
you start the cleaning function, always remove the
worst of the food residues and remnants from the
cooking compartment.Do not use the cleaning
function for cleaning accessories.
The appliance will become very hot on the outside
Risk of fire!
■
during the cleaning function. Never hang
combustible objects, e.g. tea towels, on the door
handle. Do not place anything against the front of
the appliance. Keep children away from the
appliance.
If the door seal is damaged, a large amount of heat
Risk of fire!
■
will be generated around the door. Do not scrub or
remove the seal. Never operate the appliance if the
seal is damaged or missing.
Setting the cleaning function
Make sure you follow all the preparation instructions
before setting the cleaning function.
The length of time each cleaning cycle runs for has
been preset and cannot be changed.
Use the function selector to set Self-cleaning V.
1.
Use the temperature selector to set the cleaning
2.
cycle.
The length of each cycle will appear on the display.
The cleaning function will start in a few seconds. The
remaining time will count down on the display.
Ventilate the kitchen while the cleaning function is
running.
The appliance door will lock shortly after the
programme starts running. The H symbol will appear on
the display.
An audible signal will sound when the cleaning function
has finished. The time on the display will be zero.
Switch the appliance off by turning the function selector
to the "Off" position.
You will not be able to open the appliance door again
until the cooking compartment has cooled down
sufficiently and the lock symbol H on the display has
gone out.
22
Delaying the end time
You can delay the end time if required. Before starting,
touch the v button until the "End" symbol is highlighted
on the display. Use the @ button to delay the end time.
The appliance will switch to standby after it is started.
Changing and cancelling
The power of the cleaning cycle cannot be changed
once it has started.
The end time can be changed while the appliance is on
standby.
If you would like to cancel the cleaning function, switch
the appliance off by turning the function selector to the
"Off" position.
The appliance door will remain locked until the cooking
compartment has cooled down sufficiently and the lock
symbol on the display has gone out.
After running the cleaning function
Allow the cooking compartment to cool down. Use a
damp cloth to wipe off the ash that has been left behind
in the cooking compartment and around the appliance
door.
Hook the rails back in.
Very bad soiling may cause white deposits to
Note:
remain on the enamel surfaces. This is residue from the
food and is harmless. It does not affect performance.
You can remove these residues using lemon juice if
required.