Electrolux 506063 Manuel - Sayfa 26
Yıkayıcı Electrolux 506063 için çevrimiçi göz atın veya pdf Manuel indirin. Electrolux 506063 28 sayfaları.
Sayfayı Yazdır
For example:
A 1
List of possible documented appliance alarms with
respective cause / cure.
Code
Description
A1
NO WATER
B1
INEFFICIENT
DRAINAGE
B2
TANK WATER
LEVEL TOO
HIGH
C1..C9
CALL THE
SERVICE
CENTRE
E1..E8
CALL THE
SERVICE
CENTRE
J8
Appliance cleaning
Cleaning must be carried out after every day of use.
Use hot water, a neutral detergent/detersive if neces-
sary, and a soft brush or sponge. If another type of
detergent is used carefully follow the manufacturer's
instructions and observe the safety rules given in the
information cards provided with the product or sub-
stance.
In order to reduce the environmental impact of pollut-
ant substances, clean the equipment (externally and
internally where necessary) with products that are
more than 90% biodegradable.
CAUTION!
Do not use steel wool or similar mate-
rial to clean s/steel surfaces. Do not
use detergents containing chlorine.
CAUTION!
Contact with chemical substances (e.g.
detergent, rinse aid, scale remover,
etc.) without taking appropriate safety
precautions (e.g. personal protection
equipment) can involve exposure to
chemical risk and possible damage to
health. Therefore always refer to the
safety cards and labels on the products
used.
J8.1
End of service and daily internal cleaning
The appliance is designed to carry out an automatic
cleaning cycle to help flush out any residues and to
guarantee greater health and hygiene.
Cleaning the tank
•
Open the door and pull out the rack with the clean
items.
28
Cause / Solution
Check that the cock is open.
Check that the water inlet filter is
clean.
Check
the
minimum
mains
pressure.
Check for obstruction on the
waste outlet pipe.
Check for obstruction on the
waste outlet pipe.
The
appliance
continues
operate, but appropriate checks
by
a
technician
are
recommended.
•
Release the door for access to the tank (Figure 22):
-
Lift the latch "S" and pull the door slightly outward.
-
Lift the latch "T" and pull the door slightly outward.
•
Remove the door by pulling it outward, making sure
it does not get stuck.
Figure 22 Release the door
•
Gently lower the door.
to
•
Remove the tank filters "C" - "D" - "E" (Figure 23).
.
.
•
Clean the filters under a water spray using a nylon
brush.
•
Refit the door (Figure 24):
-
Lift the door as far as movement permits (horizontal).
-
Push the door inward, making sure it does not get
stuck, until the latches "S" and "T" are both lowered
in the initial position (all down). This operation is cor-
rectly done when the door cannot be pulled outward
on the side of latch "S" and that of latch "T".
•
Close the door, gently lifting it.
•
Select the drain cycle by pressing button "M"
(Table 2 "Control panel").
S
T
E
Figure 23 Tank filters
T
Figure 24 Refit the door
D
C
S