Bosch HBA78B9 0 Series Kullanım Kılavuzu - Sayfa 19
Fırın Bosch HBA78B9 0 Series için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Bosch HBA78B9 0 Series 40 sayfaları.
Sayfayı Yazdır
Unscrew the retaining clips on the right and left. Lift the panel
4.
and remove the brackets from the panel (fig. C). Take out the
panel.
&
Clean the panels with glass cleaner and a soft cloth.
Do not use sharp or abrasive materials or a glass scraper. This
may damage the glass.
Fitting
When fitting, make sure that the lettering "right above" is upside
down at the bottom left.
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.
Problem
The appliance does not work.
The text "Set clock" appears in the
display. The time is not the current time.
The oven door cannot be opened. The text
"Set clock" appears in the display. The
time displayed is not the current time.
The oven does not heat up or the type of
heating selected cannot be set.
The oven does not heat up. The text
"Demo" is displayed.
"Automatic switch-off" appears in the
display.
Error messages with E
If an error message with E is shown in the display, press the
button. This cancels the error message. You may then have
0
Error message
E011
E115
1.
2.
$
3.
4.
5.
Do not use the oven again until the panels have been
correctly fitted.
Malfunction table
If a dish does not turn out exactly as you wanted, refer to the
Tested for you in our cooking studio section, where you will
find plenty of cooking tips and tricks.
ã=
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Possible cause
Defective fuse
Power cut
Power cut during self-cleaning.
Type of heating not recognised
The oven is in demo mode.
Automatic switch-off has been
activated. The oven switches off.
to reset the time. If the error is shown again, call the after-sales
service.
You can take remedial action yourself if the following error
messages are displayed.
Possible cause
A button was pressed for too long
or has jammed.
The temperature in the cooking
compartment is too high.
Insert the panel diagonally towards the back (fig. A).
Stick the retaining clips onto the right and left-hand sides of
the panel, aligning them so that the carriers are over the
screw holes, and then screw in place (fig. B).
Insert the uppermost panel diagonally towards the back. The
smooth surface must face outwards.
Put the cover back in place and screw it on.
Attach the oven door.
Risk of electric shock!
Note/remedy
Look in the fuse box and check that the circuit
breaker is in working order.
Turn the rotary selector to set the current time then
press the
button.
0
Turn the rotary selector to set the current time then
press the
0
button. Wait until the cooking
compartment has cooled down. The
disappears. You can now open the oven door.
Make the settings again.
Switch off the circuit breaker in the fuse box and
then switch back on after approx. 20 seconds. In
the next 2 minutes hold the
four seconds until the text "Demo" disappears.
Press any button. The text disappears. You can
make settings again.
Note/remedy
Press all buttons individually. Check that the
buttons are clean. If the error message remains,
please contact the after-sales service.
The oven door locks. Wait until the cooking
compartment has cooled down. Clear the error
message with the
%
symbol
H
button down for
D
button.
0
19