Bosch HBC36D754B Kullanım Kılavuzu - Sayfa 23
Fırın Bosch HBC36D754B için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Bosch HBC36D754B 36 sayfaları. Combination steam oven
Ayrıca Bosch HBC36D754B için: Kurulum Talimatları Kılavuzu (16 sayfalar), Kullanım Kılavuzu (36 sayfalar)
Sayfayı Yazdır
Problem
When cooking with steam, a lot of steam is
produced repeatedly
Steam escapes from the ventilation slots
during cooking
The appliance is not producing steam
properly
Error message "E011" appears in the dis-
play
An error message "E..." appears in the dis-
play
The appliance is not heating. "Demo" is
shown in the display
Replacing the cooking compartment bulb
Heat-resistant 230 V/25 W halogen bulbs with seals are
available from the after-sales service. Please specify the E
number and FD number of your appliance.
ã=
Risk of burns!
Allow the cooking compartment and cooking compartment light
to cool before changing the bulb.
Always use a dry cloth to remove a new halogen bulb from the
packaging, otherwise it will not last as long.
Switch off the fuse in the fuse box or unplug at the mains.
1.
Turn the cover anti-clockwise to remove.
2.
Remove the bulb and replace with a bulb of the same type.
3.
Slide the new seals and the clamping ring onto the glass
4.
cover in the right order.
Screw the glass cover with the seals back on again.
5.
Connect the appliance to the mains and reset the clock.
6.
Never operate the appliance without the glass cover and seals.
Replacing the glass cover or seals
Any damaged glass cover or seals must be replaced. Please
provide the after-sales service with the E number and FD
number of your appliance.
Possible cause
The appliance is unable to calibrate itself
automatically if cooking times are too
short
Limescale has formed in the appliance
A button was pressed for too long or is
jammed
Technical fault.
A button combination was actuated
Changing the door seal
If the seal around the outside of the cooking compartment is
faulty, it must be replaced. Replacement seals for your
appliance can be obtained from the after-sales service. Please
specify the E number and FD number of your appliance.
Open the appliance door.
1.
Pull off the old seal.
2.
Push in the new door seal at one point and pull it in all the
3.
way round. The joint must be at the side.
Check again that the seal is correctly fitted in the corners.
4.
Notes/remedy
Restore the appliance to the factory set-
ting (see section: Basic settings). Then
start steaming at 100 °C for 20 minutes
This is normal
Start the descaling programme.
Press the
0
button to delete the error
message Press all of the buttons individu-
ally and check whether they are clean
Press the
button to delete the error
0
message. Reset the clock if required.
If the error message appears again, call
the after-sales service
Disconnect the power supply and recon-
nect after 10 seconds. Within 2 minutes,
press the
button for 4 seconds
D
23