Bdcom S2510-B Donanım Kurulum Kılavuzu - Sayfa 3
Anahtar Bdcom S2510-B için çevrimiçi göz atın veya pdf Donanım Kurulum Kılavuzu indirin. Bdcom S2510-B 19 sayfaları.
Sayfayı Yazdır
Chapter 1
The document describes the characteristics and parameters of S2510-B and gives an
overview of S2510-B.
1.1 Standard Configuration
S2510-B has three parts: 8 gigabit Base-T ports and 2 gigabit SFP ports and 1 console
port, as shown in the following table:
Gigabit RJ45 port
Gigabit SFP port
Console port
No.
Abbrev.
1
PWR
2
RESET
3
SYS
4
Link/Act
S2510-B Switch Introduction
Table 1- 1 Attributes of the accessory port
Port
Figure 1- 1 Front template of the S2510-B switch
Table 1- 2 Parts at the front template of the S2510-B switch
Name
Power LED
RESET
System indicator
Link/Act indicator
S2510-B Hardware Installation Manual
Attribute
Base-T port: 10/100/1000M auto-adaptation, MDI/MDIX
auto-identification, UTP(RJ45) port
SFP port: 100/1000M SFP port, Link/ACT indicators
A rate of 9600bps, RJ45 interface
It is on when the power supply provides power
normally.
Resume to the default setting
If the indicator is always on, the system is being
started up.
If the indicator flickers, the system works
normally.
If the orange indicator is on, it means 10/100M.
If the green indicator is on, it means 1000M.
If the indicator is off, there is no signal
Remarks
- 1 -