Bosch HBC86K7 3S Series Kullanım Kılavuzu - Sayfa 18
Fırın Bosch HBC86K7 3S Series için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Bosch HBC86K7 3S Series 40 sayfaları. Compact oven with microwave
Sayfayı Yazdır
:
Risk of injury!
Never touch or clean the microwave antenna (A)!
For light soiling:
Wash the glass cover using hot soapy water.
For heavy soiling:
Clean the glass cover in the same way as the enamel surfaces
in the oven.
Refitting
Slide in the cover with the smooth side facing downwards
1.
and rest it on the grill element. (Fig. A)
Use both hands to slide it back into the two catches. (Fig. B).
2.
$
Pull the clip forwards and push the glass cover upwards. Let
3.
go of the clip. (Fig. C)
&
Remove the tea towel from the oven.
:
Risk of serious damage to health.!
Never operate the appliance without the microwave glass
cover. Microwave energy may escape.
Cleaning the glass panels
The glass panels can be removed from the oven door for
cleaning.
:
Risk of burns!
The appliance becomes very hot. Never touch the interior
surfaces of the cooking compartment or the heating elements.
Always allow the appliance to cool down. Keep children at a
safe distance.
Removal
Open the oven door.
1.
2.
Undo the two screws on the door using a TORX screwdriver
(TORX 20). Hold the door panel firmly while doing this
(Fig. A).
18
%
Position the door at an angle and pull out the panel upwards
3.
by the door handle. (Fig. B).
$
4.
Close the door.
Note: Clean the glass panels with glass cleaner and a soft
:
cloth.
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, or sharp or abrasive
cleaning aids or detergents.
Refitting
1.
Insert the door panel into the guide with both hands. (Fig. A).
Push the door panel downwards, lift it slightly and hook it in
2.
at the top (Fig. B).
$
Caution!
Make sure that the door panel is sitting flush with the control
panel.
3.
Fully open the door, while holding the panels firmly with one
hand (Fig. C).
Push the door downwards again and tighten the screws
4.
hand-tight using a TORX screwdriver (TORX 20) and close
the door. (Fig. D).
&
%
%
'