Electrolux EN2F4823BF Kullanıcı Kılavuzu - Sayfa 9
Yıkayıcı Electrolux EN2F4823BF için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Electrolux EN2F4823BF 36 sayfaları.
Sayfayı Yazdır
4. Remove the three transit bolts and
pull out the plastic spacers.
5. Put the plastic caps, that you find in
the user manual bag, in the holes.
We recommend that
you keep the
packaging and the
transit bolts for any
transport of the
appliance.
5.2 Information for installation
Positioning and levelling
Adjust the appliance correctly to prevent
vibration, noise and movement of the
appliance when it operates.
1. Install the appliance on a flat hard
floor. The appliance must be levelled and
stable. Make sure that the appliance
does not touch the wall or other units and
there is air circulation below the
appliance.
2. Loosen or tighten the feet to adjust the
level. All feet must rest firmly on the floor.
WARNING!
Do not put cardboard, wood
or equivalent materials
below the appliance feet to
adjust the level.
The inlet hose
CAUTION!
Make sure there is no
damage to hoses and there
are no leaks from the
couplings. Do not use an
extension hose if the inlet
hose is too short. Contact
the service centre for a
replacement inlet hose.
1. Connect the water inlet hose to the
back of the appliance.
45º
45º
20º
20º
2. Position it toward left or right
depending on the positon of the water
tap. Make sure that the inlet hose is not
in vertical position.
3. If necessary, loosen the ring nut to set
it in the correct position.
4. Connect the water inlet hose to the
cold water tap with 3/4'' thread.
WARNING!
The inlet water shall not
exceed 25 °C.
Water drainage
The drain hose should stay at a height of
no less than 60 cm and not more than
100 cm.
You can extend the drain
hose to maximum 400 cm.
Contact the authorised
service centre for the other
drain hose and the
extension.
ENGLISH
9