AirStage UTY-RNKG Kullanım Kılavuzu - Sayfa 6
Kontrolör AirStage UTY-RNKG için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. AirStage UTY-RNKG 13 sayfaları. Wired remote controller
Ayrıca AirStage UTY-RNKG için: Kurulum Kılavuzu (8 sayfalar)
Sayfayı Yazdır
OPERATION
NOTES
(1) • Always use the "
Attempting to move the airflow direction louvre
manually could result in improper operation; in this case, stop
operation and restart.
The louvre should begin to operate properly again.
• During cooling operation, do not set the vertical airfl ow direc-
tion louvre in the downward position for an extended period.
Water vapor may condense near the outlet port and drops
of water may drip from the air conditioner.
(2)
The SWING operation may stop temporarily when the air
conditioner's fan is not operating, or when operating at very
low speeds.
(3)
The swing operation is not available depending on the model.
Please refer to the operating manual for the indoor unit.
ECONOMY OPERATION
To set the economy operation
● Economy setting
NOTES
About ECONOMY Operation
Economy operation can be set by remote controller.
The temperature setting is offset automatically over a certain period of time.
Based on temperature set in remote control unit, temperature of indoor unit varies little by little. However in this case, temperature
indication of remote control unit does not vary as it continues to indicate the temperature when ECONOMY Operation was set.
Save temperature
Cooling set temperature
Heating set temperature
Save temperature
En-5
" button or the "
" button.
°C
Cooling
2
Operation
1
0
0
1
Heating
Operation
2
3
4
<Vertical airfl ow swing operation>
Airfl ow direction
Range of swing
1
2
3
4
<Horizontal airfl ow swing operation>
Airfl ow direction
Range of swing
1
2
3
4
5
• Press the "START / STOP" button to set the air conditioner in
the operation mode.
Then, proceed with the following steps.
Press the "ECONOMY /
stop the energy-saving air conditioner operation.
• The energy save air conditioner operation is not available
depending on the model.
0
30
60
90
ECONOMY operation
Start
1 to 4
(All range)
4
1 2
3
1 to 5
(All range)
THERMO SENSOR" button to start or
Min.
1
2
3
4 5