Carl Wittkopp FinKey VdS Class 1 Hızlı Başlangıç - Sayfa 2

Kilitler Carl Wittkopp FinKey VdS Class 1 için çevrimiçi göz atın veya pdf Hızlı Başlangıç indirin. Carl Wittkopp FinKey VdS Class 1 2 sayfaları. Electronic lock

Sayfayı Yazdır

FinKey (VdS Class 1) - Quick start

1 Notes on safety

• After programming the user finger, the electronic lock should be opened and locked several times.

• After each locking doublecheck if the safe is closed.

1.1 Notes on safety emergency lock

• Due to security reasons it is recommended not to leave the key unattended in the lock.

• Don't store the key in the safe.

• The keys have to be stored at a safe place and may only be accessible by authorised persons.

• When losing the key exchange the lock immediately.

• Make sure after each locking if the safe is locked.

Detailed installation/operating instructions are available for download on our website carl-wittkopp.com.

2 Programming of master fingers

The same finger (recommendation) or three different ones can be programmed as master finger.

1. Red, green and blue LED flashes permanently.

2. Pull the 1st master finger over the sensor.

3. Wait until the green and red LED flashes.

4. After 3 sec. pull the 2nd master finger over the sensor.

5. Wait until the green and red LED flashes.

6. After 3 sec. pull the 3rd master finger over the sensor.

7. Wait until the green LED flashes.

3 Programming of user fingers

The master finger should not be the user finger.

1. Blue LED flashes permanently.

2. Pull the master finger over the sensor.

3. Pull the user finger several times over the sensor.

4. Wait until the green and red LED flashes simultaneously.

4 Opening / locking

1. Blue LED flashes permanently.

2. Pull the user finger over the sensor.

3. Turn the handle within 3 seconds into "opening" / "locking" position.

Rel. 1.1

12.07.2017

Quick start no. 600-0005-00-0