BDI S100 STINGER Hızlı Başlangıç Kılavuzu - Sayfa 2

Test Ekipmanları BDI S100 STINGER için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. BDI S100 STINGER 4 sayfaları.

1. Connect the lug on the red cable from the bonder handle to the smaller terminal. Then install and hand-tighten the

wing nut again. Do not over tighten.

2. Line up the 3-pin connector from the handle with the receptacle on the panel. Twist the barrel of the connector to

secure it.

3. Use either cable with the magnetic clamp or the mechanical clamp. Connect clamp to bare, clean steel. To activate

the magnetic clamp, place it on a bare, clean steel surface then turn the switch to ON.

4. Insert the battery pack into the handle in the orientation shown in the drawing below until the pack snaps into place.

Charge the battery pack before use.

BDITEST.COM