Drazice OKH 125 NTR Kullanım ve Kurulum Kılavuzu - Sayfa 5
Su Isıtıcı Drazice OKH 125 NTR için çevrimiçi göz atın veya pdf Kullanım ve Kurulum Kılavuzu indirin. Drazice OKH 125 NTR 14 sayfaları. Tank type indirect water heaters
Ayrıca Drazice OKH 125 NTR için: Kullanım ve Kurulum Kılavuzu (16 sayfalar), Kullanım ve Kurulum Kılavuzu (17 sayfalar), Kullanım ve Kurulum Kılavuzu (12 sayfalar)
Sayfayı Yazdır
1.3 DESIGN AND GENERAL HEATER DIMENSIONS
The heater receptacle is made of a steel plate and tested by 0.9 MPa overpressure. The inside of the
receptacle is enamelled. A flange is welded onto the upper bottom of the receptacle with a flange lid is
screwed to it. A sealing ring is inserted between the flange lid and the flange. Thermowells for thermostat
sensors and thermometer installation are placed in the flange lid. Anode rod is mounted on M8 nut. The
water reservoir is insulated by means of polyurethane foam. Electric wiring is placed underneath the plastic
removable cover. The temperature of water can be set using the thermostat. Heat exchanger is welded in
the pressure tank.
Technical description: OKH 100 NTR, OKH 125 NTR, OKH 160 NTR
Figure 1
Technical desription: OKH 100 NTR/HV, OKH 125 NTR/HV
Figure 2
1 Thermometer
2 Enamelled steel receptacle
3 Heater shell
4 Polyurethane freon-free insulation
5 Tubular heat exchanger
6 Discharge outlet
7 Cold water filling pipe
8 Circulation
9 Mg anode
10 Hot water drain pipe
11 Electric installation cover
1 Thermometer
2 Enamelled steel receptacle
3 Heater shell
4 Polyurethane freon-free insulation
5 Tubular heat exchanger
6 Discharge outlet
7 Cold water filling pipe
8 Circulation
9 Mg anode
10 Hot water drain pipe
11 Electric installation cover
- 5 -