Drazice OKC 200 NTRR / BP Kullanım ve Kurulum Kılavuzu - Sayfa 12

Kazan Drazice OKC 200 NTRR / BP için çevrimiçi göz atın veya pdf Kullanım ve Kurulum Kılavuzu indirin. Drazice OKC 200 NTRR / BP 20 sayfaları. Stationary water heaters
Ayrıca Drazice OKC 200 NTRR / BP için: Kullanım ve Kurulum Kılavuzu (17 sayfalar), Kullanım ve Kurulum Kılavuzu (12 sayfalar), Kullanım ve Kurulum Kılavuzu (19 sayfalar), Kullanım ve Kurulum Kılavuzu (20 sayfalar), Kullanım ve Kurulum Kılavuzu (20 sayfalar), Kullanım ve Kurulum Kılavuzu (18 sayfalar), Kullanım ve Kurulum Kılavuzu (18 sayfalar), Kullanım ve Kurulum Kılavuzu (13 sayfalar)

Sayfayı Yazdır
Drazice OKC 200 NTRR / BP Kullanım ve Kurulum Kılavuzu

2.4 ELECTRICAL INSTALLATION

2.4.1 GENERAL INFORMATION FOR ELECTRICAL INSTALLATION

Perform the connection according to the scheme. Factory connection must not be changed! (Obrázek 5). In
the electric wiring casing remove the partition corresponding with the input wire diameter of φ8 or φ10
(Figure 4).The degree of protection of electric parts of the heater is IP 44. Power input of electric element is
2000 W.
It is necessary to observe the below requirements during the electric wiring.
•
The wiring diagram is attached to the heater on the side of the electric installation
guard (see Fig. 5).
•
Connection, repairs, and wiring inspections may only be implemented by a company
(person) authorised to such activity.
•
Expert connection must be confirmed on the warranty certificate.
•
The heater is connected to the 230 V/50 Hz electrical network using a fixed moving
conductor with a switch that turns off all network poles and the circuit breaker
(protector).
•
Installations in bathrooms, laundry rooms, rest rooms and showers, must be in
compliance with standard.
•
The degree of protection of electric parts of the heater is IP 44.
•
Adhere to the protection against electric shock injury according to standard.
Figure 4
Figure 5
- 12 -