Bosch HVA541NS0 Kullanım Kılavuzu - Sayfa 9
Fırın Bosch HVA541NS0 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Bosch HVA541NS0 16 sayfaları.
Ayrıca Bosch HVA541NS0 için: Kullanım Kılavuzu (32 sayfalar)
Sayfayı Yazdır
Area
Cleaning agents
Enamel surfaces
To facilitate cleaning, you can switch on
(smooth surfaces)
the interior lighting and detach the appli-
ance door if necessary. Apply commer-
cially available washing-up liquid or a
vinegar solution with a soft, damp cloth
or chamois; dry with a soft cloth. Loosen
baked-on food residues with a damp
cloth and detergent. We recommend
using oven cleaning gel if the oven is
very dirty. This can be applied to the
affected area. Leave the cooking com-
partment open after cleaning to allow it
to dry.
Self-cleaning sur-
Please see the notes in section: Self-
faces (rough sur-
cleaning surfaces
faces)
Door panels
Glass cleaner:
Clean with a soft cloth. Do not use a
glass scraper.
Glass cover for the
Hot soapy water:
oven light bulb
Clean with a dish cloth.
Seal
Hot soapy water:
Do not remove.
Clean with a dish cloth. Do not scour.
Shelves
Hot soapy water:
Soak and clean with a dish cloth or
brush.
Accessories
Hot soapy water:
Soak and clean with a dish cloth or
brush.
Catalytic cooking compartment panels
The catalytic cooking compartment panels are coated with self-
cleaning enamel.
The surfaces clean themselves while the oven is in operation.
Larger splashes will only be removed after the oven has been
used several times.
Self-cleaning surfaces
The side walls are covered with catalytic panelling. Never clean
these surfaces with oven cleaner. Slight discolouration of the
enamel does not affect automatic self-cleaning.
Removing and installing the door panels
To facilitate cleaning, you can remove the glass panels from the
oven door.
Removing the door panels
Open the oven door fully.
1.
Lock both hinges on the left and right using the locking pin.
2.
Note: The locking pins must be fully inserted into the holes in
the hinges.
Lift the bottom of the inner panel slightly until the fastening
3.
pins come out of the holder (1).
Carefully lift the top of the inner panel until the fastening pins
4.
come out of the holder (2).
Caution!
When lifting the inner panel, the middle panel may stick to the
inner panel. Make sure that the middle panel does not fall.
Remove the inner panel.
5.
Remove the middle panel.
6.
Note: The middle panel is kept in place with rubber bushings
rather than retaining pins.
Clean the panels with glass cleaner and a soft cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, sharp or abrasive cleaning
aids or detergents.
9