Bosch Vision 800 Series Servis Kılavuzu - Sayfa 10
Fırın Bosch Vision 800 Series için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Bosch Vision 800 Series 36 sayfaları. Gas slide-in ranges
Ayrıca Bosch Vision 800 Series için: Kullanım Kılavuzu (40 sayfalar), Boyutlar ve Özellikler (2 sayfalar), Kurulum Kılavuzu (6 sayfalar), Servis Kılavuzu (43 sayfalar), Kurulum Talimatları Kılavuzu (28 sayfalar)
Sayfayı Yazdır
58300000194725 ARA EN B
Cooking Mode
Burners Used
Bake
Roast
Bake, Conv Fan
Pizza
Bake
Warm
Bake
Proof
Bake, Conv Fan
Convection Bake
Bake, Conv Fan
Convection Roast
Table 3 Active burners by cooking mode
4.2.2
Setting Temperature Offsets
In some cases, it may be necessary to adjust the oven temperature if
the customer reports that food is consistently under- or over-cooked,
even though the oven is operating normally. Temperature Offsets can
be entered by the customer from the Customer Settings menu to raise
or lower the cavity temperature during operation in Bake, Convection
Bake, Roast and Convection Roast.
The allowable Offset range is from 0°F to 35°F, positive or negative,
in 1° increments.
1. Press Settings to access the Customer Settings menu (from
stand-by mode only)
2. Press 9 for Temperature Offset (single/upper) or 10 (lower).
Copyright by BSH Home Appliances Corporation
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
Description
Bake burner generates heat and cycles to
maintain oven temperature
Bake burner generates heat and cycles to
maintain oven temperature, while the
heat is circulated by the convection fan.
Bake burner generates heat and cycles to
maintain oven temperature
Bake burner is used to maintain a low
temperature
Lower burner cycles to generate heat and
maintain oven temperature while the heat
is circulated by the convection fan.
Lower burner cycles to generate heat and
maintain oven temperature while the heat
is circulated by the convection fan.
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
MAY 2016
3. Press Enter to edit the current setting.
4. Press (-) or (+) then enter the offset value using the numeric
keys - always enter the value as 2 digits (i.e, 05).
The new value is saved when the display changes from edit
mode back to display mode.
5. Press Clear On/Off to exit the Settings menu.
Example: A +25° offset will result in a cavity temperature of 350°
when the cooking temperature is set to 325° for any of the cooking
modes affected by the Offset. Similarly, a -25° offset will result in a
cavity temperature of 300° when the cooking temperature is set to
325°.
The adjusted temperature cannot be less than the minimum allowable
temperature for the cooking mode, nor higher than the maximum for
the cooking mode. See Allowable Operating Range by Cooking Mode
section.
4.3
Cooling Fan
The cooling fan is used to maintain allowable temperatures on internal
components and customer-accessible surfaces.
The cooling fan turns on low speed when the cavity temperature is at
or above 300°F/150°C. The fan will continue to run for 15 minutes
after the mode has been cancelled.
During Self-clean, the cooling fan turns on high speed when the cavity
temperature reaches 300°F/150°C and will continue running for 15
minutes after the door unlocks (@255°C/491°F).
Service Manual for Bosch 800 Series Gas Slide-in Ranges
Page 10 of 36
800 944-2904