Dreadbox Erebus Kullanıcı El Kitabı - Sayfa 7

Sentezleyici Dreadbox Erebus için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Dreadbox Erebus 8 sayfaları. Analog paraphonic synthesizer
Ayrıca Dreadbox Erebus için: Kullanıcı Kılavuzu (13 sayfalar), Kullanıcı Kılavuzu (15 sayfalar), Yapım Kılavuzu (12 sayfalar)

Sayfayı Yazdır
Dreadbox Erebus Kullanıcı El Kitabı
2.9 Patching
EREBUS's right side is dedicated to patching. Learning to patch needs lots of experimentation. We
strongly suggest spending lots of time and trying as much connections as possible. You will find out
that half the possibilities of the synth comes from it. Patching is divided in 3 areas:
OUTPUTS - those patches only send voltage. You can send their CV to other devices, but first be sure
that the receiver can accept such a voltage.
INPUTS - those patches can only receive voltage. It's safe to send much more voltage than indicated
(see specs or chap. 9B) but it won't always have results.
MIDI INTERFACE - those patches are for MIDI and Audio handling.
A. OUTPUTS
MOD: Modulation Wheel. Sends 0-5V and it can be controlled by the
Midi Keyboard's modulation wheel. The small depth knob above,
acts as an attenuator, it limits the maximum voltage to be delivered.
GATE: Sends note on/off from the midi keyboard in the analog form
of 0V(off) 5V(on).
ENV: Sends 0-5V from the ADSR envelope generator. Again the
small knob above acts as an attenuator.
CV1: Sends the 1V/Oct that Oscillator 1 is currently using.
CV2: Sends the 1V/oct that Oscillator 2 is currently using. When in
Unison mode, this is exactly the same amount of voltage as CV1.
LFO: Sends the LFO output to a +/-5V form. This is the only way to
use the LFO, as it is not hard-wired.
NEVER CONNECT AN OUTPUT WITH ANOTHER OUTPUT
This might cause serious damage to the unit and Dreadbox will not take any responsibility.
TIP:
CV1, CV2 and gate are great to use with other cv/gate controlled devices to achieve paraphony. You
may also multiply the gate to control two different devices at a time. Sending CV1 at one and CV2 to
the other will make them work in a paraphonic way between them.