Bosch 1584AVS Kullanım/Güvenlik Talimatları Kılavuzu - Sayfa 8
Elektrikli Alet Bosch 1584AVS için çevrimiçi göz atın veya pdf Kullanım/Güvenlik Talimatları Kılavuzu indirin. Bosch 1584AVS 33 sayfaları. Bosch operating instructions jig saw 1584vs, 1584avs, 1584dvs
Ayrıca Bosch 1584AVS için: Parça Listesi (3 sayfalar)
Sayfayı Yazdır
BM 2610993482 2-04
2/9/04
The following types of blades should only be
used with orbital Setting O:
1. Blades with teeth that point downward
(reverse-tooth blades).
FOOTPLATE ANGLE ADJUSTMENT
The footplate may be tilted to allow angle cuts
up to 45˚ in either direction. To adjust
footplate, loosen screw (A) with allen wrench,
slide the footplate towards the front of the tool,
and rotate to the desired angle, as marked on
the angle scale. Detent slots will hold the
footplate firmly at 0˚, and there are additional
position marks for 15˚ and 45˚ angles.
SCREW (A)
FOOTPLATE
PROTRACTOR
(Not included)
FOOTPLATE INSERTS
(1584AVS & 1584DVS)
Model 1584AVS & 1584DVS will accept two
footplate inserts which may be changed by
removing the six screws (B). The steel insert is
used for most general cutting operations, and
the smooth plastic insert may be used to
minimize scratches on fine surfaces.
SCREW (B)
(1584AVS & 1584DVS)
ANTI-SPLINTER
INSERT
FOOTPLATE INSERT
(1584AVS & 1584DVS)
FOOTPLATE
9:17 AM
Page 8
2. Blades with teeth that point straight out
rather than up or down.
3. Carbide-tipped blades.
4. Grit-edge blades.
Intermediate angles may be set with a
protractor. After positioning the footplate,
securely tighten screw (A).
On model 1584DVS, screw (A) is covered by
sliding cover, which should be closed after
making the footplate adjustment. Note that
when the footplate is used on an angle, dust
cover must be removed, and chip collection
efficiency will be reduced.
ANTI-SPLINTER INSERT
To minimize splintering of the top surface of
the material being cut, place the anti-splinter
insert in the blade opening of the footplate.
Note: This insert will only work with blades
that have ground sides such as T301CD,
T101B, T101D, and T101DP.
SCREW (A)
COVER (1584DVS)
-8-
DUST PORT
(1584DVS)