Anchor NAVI-TRAC NAV40GBL-1104 Kullanıcı Kılavuzu - Sayfa 12

Çadır Anchor NAVI-TRAC NAV40GBL-1104 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Anchor NAVI-TRAC NAV40GBL-1104 16 sayfaları. Frame tent system, 40’ wide gabled end system

Sayfayı Yazdır

COMPLETING THE TOP FRAME

REPEAT PREVIOUS STEPS UNTIL ALL

BEAMS ARE VERTICAL AND BOTH

END BAYS ARE X-CABLED, AS SHOWN.

INSTALLING GUY WEBS BEFORE INSTALLING FABRIC

STAKING DISCLAIMER: DUE TO VARYING SOIL CONDITIONS AT

EACH INSTALLATION SITE, THE STAKES PROVIDED MAY NOT

MEET THE LOADING REQUIREMENT SHOWN ON THE BLUEPRINT

AND ENGINEERING ANALYSIS. IT IS THE INSTALLERS RESPON-

SIBILITY TO VERIFY THE SOIL CONDITIONS AND PROPER

ANCHORING DEVICES REQUIRED AT EACH SITE TO ENSURE A

SAFE INSTALLATION.

ATTACH GUY WEBS TO EAVE WELDMENTS AND STAKE OUT

AT A 45 DEGREE ANGLE (DISTANCE OUT = HEIGHT OF UPRIGHT,

USUALLY 8 FT. USE 42" STAKES PROVIDED.

X-CABLED BAYS

STAKE PLATES AT PROPER SPACING

BEFORE INSTALLING THE X-CABLES.

THEN, ADJUST TURNBUCKLES UNTIL

CABLE IS SNUG

INSTALLING GABLED END FRAME

UG-15

EW-15

INSTALL GABLED END FRAME. MAKE

CONNECTIONS IN THE ORDER SHOWN.

11-T-a

NAVI-TRAC UNITS 100 FT OR MORE IN LENGTH

MUST HAVE AN X-CABLED BAY (NEAR THE MID-

DLE AND/OR EVENLY SPACED) FOR EVERY 100

FT OF LENGTH.

X-CABLING FROM EAVE TO BASEPLATE (AS

SHOWN) ON BOTH SIDES OF THE STRUCTURE.

SUBSTITUTE BOLTS FOR PINS AT THE TOP OF BOTH

UPRIGHTS. THREADS SHOULD POINT INWARD

TOWARD EACH OTHER. THREAD CABLE EYENUTS

ONTO EACH BOLT TO SECURE THE CABLE.

REMOVE THE NUTS FROM THE BOLTS THAT PIN THE

BASEPLATE TO THE UPRIGHT. TURN THE BOLTS SO

THAT THE THREADS ARE TO THE INSIDE (FACING

EACH OTHER). THREAD THE CABLE EYENUTS ONTO

THE BOLTS TO SECURE THE CABLE.

EE-10

BFW

T-30