Anchor megavox Kullanıcı El Kitabı - Sayfa 5
Hoparlör Sistemi Anchor megavox için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Anchor megavox 7 sayfaları. Portable
Ayrıca Anchor megavox için: Hızlı Başlangıç Kılavuzu (2 sayfalar), Hızlı Başlangıç Kılavuzu (2 sayfalar), Hızlı Başlangıç Kılavuzu (2 sayfalar)
Sayfayı Yazdır
100-58-0/B MGX 2/6/01 9:49 AM Page 9
Wireless Operation
Setting up the wireless system
Consult the
supplemental
Set the frequency of the receiver.
wireless
The wireless receiver is mounted inside the MegaVox and is
manual if you
available with two different frequency pairs (this allows for
have model
PB-35WS.
operation of up to 4 units simultaneously). A label on the
control panel indicates which 2 frequencies your system is
equipped with, and the desired frequency is selected via the
frequency switch.
TX ON
1. Set the frequency of the receiver to either of the two
channels, F1 or F2.
If you experience ongoing interference problems with your
wireless system, the selected frequency may be incompatible
with other RF systems in your area. Try the other channel.
Set the frequency of the transmitter.
During use, make sure the transmitter you are using is set to
the same frequency as the receiver as set above.
HANDHELD: Set the frequency switch inside the
battery compartment to match the channel of the
receiver. Replace the cover—but don't overtighten!
BODY-PACK: The power/frequency switch on the
transmitter determines the frequency. During use, set
8
the switch to match the frequency of the receiver.
(PB-35W)
label indicates frequency pair
F1
F2
169.445
(MHz)
PB-35W-1: 169.445
170.245
170.245
PB-35W-2: 171.105
171.845
frequency switch
Frequency Switch
Operation
MegaVox Control Panel
Power / Battery
Indicator
Mic 1 Input
(1/4" phone jack)
(MHz)
Charger Input
(use RC-16 only;
RC-16/220 for export)
Charging Indicator
Wireless
Reception
Indicator
(PB-35W only)
Operating the sound system
Mic 2 Input
Power Switch
(1/4" phone jack)
OFF
Flashing =
low battery
ON
POWER
MIC
2
MIC 1
LINE IN
LINE OUT
(WIRELESS)
PB-35W
SPKR OUT
CHARGER
use
Anchor
RC-16
Flashing =
fully charged
only
TX ON
169.445
CA
170.245
1. Set all input level controls to minimum before
turning on the power.
2. Plug a microphone into one of the Mic input jacks,
or connect an audio source to the line input.
3. Turn power ON (red LED next to switch will light).
If the LED flashes or does not light, the battery must be
charged (see page 7).
4. Adjust the level control adjacent to the input used to
desired volume level.
Line Input
(1/4" phone jack)
Line Output
(1/4" phone jack)
Speaker Output
(1/4" phone jack)
Wireless
Frequency Switch
(PB-35W only)
5