Anchor Megavox Pro MEGA-6000U1 Kullanıcı El Kitabı - Sayfa 6
Hoparlör Sistemi Anchor Megavox Pro MEGA-6000U1 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Anchor Megavox Pro MEGA-6000U1 8 sayfaları. Anchor mega-6000u1: brochure
Ayrıca Anchor Megavox Pro MEGA-6000U1 için: Katalog (2 sayfalar), Kullanıcı El Kitabı (4 sayfalar), Teknik Özellikler (1 sayfalar), Teknik Özellikler (1 sayfalar), Kullanıcı El Kitabı (16 sayfalar)
Sayfayı Yazdır
Single Unit Setup
Place the unit along the aisle with the least amount of pedestrian
traffic. Point the unit towards the center of the audience.
Connect A MegaVox Pro Companion Speaker
NOTE:
Use a speaker cable (SC-50) to connect Speaker Out on the primary
The line-out
unit to the unpowered companion speaker (MEGA-6001).
connection
No electric power is required for an unpowered companion speaker.
can also be
used to send
Connect MegaVox Pro Powered Systems
the signal to a
sound system
Utilize the Line Output feature by connecting a cable (EX-50PP)
in a different
from Line Out of the primary MegaVox Pro to Line In on the
room or a
secondary powered MegaVox Pro. Connect the second MegaVox
recording
Pro to an electrical outlet and turn the unit on. Set the volume of the
device.
second Megavox Pro to maximum so full volume control will be at
the primary system.
Primary
Powered
MegaVox Pro
4
SYSTEM SETUP
Secondary
Powered
MegaVox Pro
Line Out - to - Line In Connection
GENERAL OPERATION
Mic 1
(MEGA-6000 only)
An unbalanced, low impedance microphone input. For use with the
wired mic supplied with your unit, or any mic with a 1/4" phone
plug which does not require phantom power.
Mic 1/Wireless
(MEGA-6000U1 only)
The built-in receiver is connected to this input. Use the controller to
adjust the wireless mic volume. Inserting a plug into this input
disconnects the wireless input—to use a wired and wireless mic
simultaneously, plug the wired mic into the Mic 2 input.
Mic 2/Signal
An unbalanced, low impedance microphone input. For use with the
wired mic supplied with your unit, or any mic with a 1/4" phone
plug which does not require phantom power. The controller adjusts
both the signal alert and mic volume.
Line In
The line input (1/4"-phone jack) is used for playback of a tape
player, musical instrument or similar source. It may be used
simultaneously with the mic inputs for a composite output.
Line Out
The output signal is a composite of all the inputs. Use it to record
your presentation, or to "daisy chain" another powered sound system
to the MegaVox Pro for greater crowd coverage.
Speaker Out
Use the speaker output to drive Anchor's model MEGA-6001
companion speaker (in addition to MegaVox Pro's built-in speakers)
for greater output. When an external speaker is powered by the
MegaVox Pro, battery service per charge will decrease considerably.
Signal Alert Button
The Signal Alert provides an air horn type tone. The level is
controlled by the MIC/SIGNAL volume control. Caution, this can
produce VERY high or harmful sound pressure levels.
9