Formax FD 452 Operatör El Kitabı - Sayfa 4

Ofis Ekipmanları Formax FD 452 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Formax FD 452 4 sayfaları. Envelope opener

Safety

Before using your letter opener, please read this document and keep it near the machine as a

reference.

The letter opener complies with standard safety regulations for office equipment of this type. Before

operating it, read the following tips to assure safe operation:

Carefully follow the instructions for installation and operation of the letter opener.

Connect the letter opener to a grounded single-phase power outlet.

Do not remove any parts.

All maintenance and repair must be done by an authorized Formax service technician. Failure to

observe this rule will void your warranty.

Do not use water or benzene to clean your letter opener.

Avoid operating the letter opener without any envelopes in it. This will reduce the lifetime of the

machine.

Troubleshooting

Problem

The letter opener does not

feed envelopes into the cutting

unit.

Letters are jammed in the

cutting unit.

Letters are not opened

properly.

NOTE: Under no circumstances should you use anything such as a pair of scissors to remove any bits

of paper from the cutting unit.

Maintenance

To keep the unit in peak operating condition, periodically clean the feed rollers with a moistened cloth.

Solution

Apply a slight amount of pressure to the pressure arm or stack of

envelopes until the envelopes are fed again one by one.

1. Remove the stack of letters, which are not jammed, from the

feeder. Apart from the envelope that is jammed, pull the remaining

envelopes out of the cutting unit.

2. Then, pull the jammed envelope out of the cutting unit in the

direction of transport (see illustration).

Contact your authorized Formax dealer.