Formax FD 90 Operatör El Kitabı - Sayfa 9

Ofis Ekipmanları Formax FD 90 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Formax FD 90 11 sayfaları. Rotary perforators
Ayrıca Formax FD 90 için: Operatör El Kitabı (11 sayfalar)

Sayfayı Yazdır

Replacing & Adjusting Perforating Tools or Creasing Wheels (cont.)

NOTE: Always put indented cutting tools on the upper shaft (20). Place the tools (21, 27) on the shaft in a mirroring way

starting from the center of the shaft. An odd pair of tools must always be oriented according to the half of the adjusted

sheet on which that pair of tools is placed. The guide pulleys (19, 24) must always be on the outer edge of the document

in a mirrored position. If the tools are oriented only on one side of the document, the mirroring plane equals one half of the

distance between the tools located in the farthest positions.

28 = 21, 22, 27

Figure A

To process 60 g/m

paper, an optional set of guide strips must be used and positioned as shown above. Magnets will hold

them in place on the upper and lower covers.