Ancona 450 CFM Kullanıcı Talimatları - Sayfa 6

Havalandırma Davlumbazı Ancona 450 CFM için çevrimiçi göz atın veya pdf Kullanıcı Talimatları indirin. Ancona 450 CFM 6 sayfaları. Wall mount pyramid rim 30 inches

Sayfayı Yazdır

WALL MOUNTED STAINLESS STEEL RANGE HOOD

INSTALLATION

 Make the holes that correspond with the centre of the cooktop, so that the

lower part of the hood, which is to be assembled afterwards, is arranged at

least 61 cm (24") from the stove top for electric models and at least 76 cm

(30") for gas models. (See Pic 9)

 Installing range hood hook: Drill 3 holes in a suitable place according to

size of hook, use screws to fix the hook on the wall.

 Installing chimney bracket: drill 2 holes according to size of inside chimney

bracket in a suitable position, the position of bracket should be flush with the

top of the outside chimney. (See Pic 10)

 Fix the damper on the top vent of hood with 4 screws (See Pic 4), then

install the ducting pipes onto the damper. (See Pic 11) - If the ventilation

system is equipped with an external air duct with a different diameter, apply

a reduction fitting. However for maximum performance and safety 6" Ø

ducting is recommended.

 Use 2 screws to fix two chimneys together with the outside chimney bracket,

make sure inside chimney is moving freely. (See Pic 12)

 Install the chimneys on the hood. (See Pic 13)

 Fix the chimney and hood together with two screws. (See Pic 14) – This step

is just for the models which have holes on bottom of outside chimney.

 Hang the hood on the range hood hook. (See Pic 15)

 Pull out the inside chimney and adjust height according to the position of

inside chimney bracket on the wall, then fix the inside chimney on the

bracket with two screws. (See Pic 16)