Alentec & Orion 24702 Kullanıcı Kılavuzu - Sayfa 7
Ölçüm Cihazları Alentec & Orion 24702 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Alentec & Orion 24702 8 sayfaları. Hose end meter pre set version
Sayfayı Yazdır
Manual 24702_EN_2B
Instruction for changing the unit of measure
RESET
STRAINER EXCHANGE
The strainer should be checked if a
decrease in flow is noticed. If necessary,
exchange it with the extra strainer
delivered with the Meter.
1. Remove the hexagon screw that covers the SETUP button.
2. With a sharp object, like a small screwdriver, short-circuit the
two soldered pads on the circuit board that can be reached
through the hole. These must remain short-circuited during the
entire setting procedure.
3. The actual Unit of Measure is now flashing on the display.
Use the RESET button to select the desired Unit of Measure.
4. Release the SETUP button and test the Meter against a
measure. If the Meter reading is accurate, replace the hexagon
screw.
TECHNICAL DATA
P
:
735 psi (5 Mpa)
max
Q
:
1 l/min (1 q/min)
min
Q
: 15 l/min (16 q/min)
max
T
: 32 °F / 122 °F (0°C / 50°C)
min/max
Err
: < 1%
±max
m: 1.88 lb (0.85 kg)
7(8)