Electrolux ESF 2420 Talimat Kitabı - Sayfa 10

Bulaşık Makinesi Electrolux ESF 2420 için çevrimiçi göz atın veya pdf Talimat Kitabı indirin. Electrolux ESF 2420 20 sayfaları. Dishwasher
Ayrıca Electrolux ESF 2420 için: Enstitü Kitabı (16 sayfalar)

Sayfayı Yazdır

Using the appliance

Starting the programme

1. Scrape or rinse off solid food remnants.

2. Load the dishwasher.

(See the basket and loading).

3. Put the correct amount of detergent into the

detergent dispenser and close the dispenser lid.

4. Close the door.

5. Select the required programme (see programme

chart). The programme indicator lamps starts to

ﬂash.

6. Press in the start button. The lamp for the start

button comes on and dishwashing cycle starts.

The programme indicator lamps always indicates

which part of the selected cycle the dishwasher

is in.

7. Check the ﬁlters to see if they need to be cleaned

when the dishwasher has ﬁnished the programme.

Interrupting the programme temporarily

1. Open the door. The programme stops.

2. Close the door and the programme continues

after about six seconds.

Open the door carefully when the dishwasher

is running, since hot steam may escape.

Cancelling the programme

1. Press and hold in the start button until the lamp

for the start button goes out.

2. Release the button, the programme indicator

lamps starts to ﬂash.

3. Turn the programme selector to the "Reset"

position. The programme is now cancelled and

a new programme can be selected.

If you simply turn the programme selector to the

"Reset" position, the selected programme is not

ﬁnished, it is only disrupted. The programme will

continue if you turn the programme selector to

the programme again.

Cancelling the drying phase

In case you do not want to wait until the drying phase is

completed, you can cancel it.

1. Press and hold in the start button until the

programme indicator lamps starts to ﬂash,

then release the button.

2. Open the door. The drying phase is cancelled.

Switching the dishwasher off

Switch the dishwasher off, when the indicator lamp

for the programme cycle end is lit.

1. Turn the programme selector to the "Reset"

position. All indicator lamps goes out.

2. Leave the door slightly ajar.

Be careful if you open the door immediately

after the programme is ﬁnished, since hot

steam may escape.

- 10 -