FormFit HD 23A 07 Kurulum Talimatları

Otomobil Aksesuarları FormFit HD 23A 07 için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. FormFit HD 23A 07 4 sayfaları. Hood protector gmc 1/2 ton truck 2007

Sayfayı Yazdır

FORM FIT

GMC ½ Ton Truck 2007 -

Hardware Kit

3 – Adhesive Backed Pedestals

3 – Square Expansion Plugs

3 – #8 x 7/16" Black Screws

3 – Large Bumpons

1 – Alcohol Wiping Pad

1 – 3M Adhesive Promoter

Installation

1. Be sure that the hood is clean and dry inside and out.

2. Locate the center of the hood using tape measure and the upper grill insert or body lines as references. Place a piece of masking tape on top of the grill

near center, where the grill meets the painted surface of the hood. Mark the masking tape with a pencil at the center. See Illustration.

3. Place two (2) additional pieces of masking tape on the grill to mark the location of the adhesive backed pedestals. Mark the masking tape with a pencil at

the location as shown.

4. Install the square expansion plugs into the top of the adhesive backed pedestals. Use the centering notch on the pedestals to align it's location with

the pencil mark on the tape in the previous Step. Note: When located correctly the pedestal leading edge will butt against the back of the grill

surround at all 3 locations.

5. Temporarily tape the pedestals to surface of the hood in their determined positions, confirm correct placement by placing the hood protector on top of the

three pedestals. When positioned correctly the three (3) holes in the center area of the protector will align with the holes in the expansion plugs. Adjust

if necessary and reconfirm the pedestal locations using the measurements in the illustration and the hood protector.

6. Remove the pedestals and clean the contact with alcohol wiping pad.

Tip: Before removing the pedestals, use masking tape to outline the area of the hood where the pedestals will mount. After installation the tape can be

removed and there will be no clean up of the mounting area required and final placement of the pedestals will be easier. See Illustration.

HOOD PROTECTOR

4 – 3M Anti-Abrasion Film Pad

4– Clip Bodies

4 – Pins

4 – 'L' Brackets

4 – #6 x 5/8" Flat Head Screws

315mm

CENTER

315mm

HD 23A 07

Tools Required

1 – Phillips Screwdriver #2

1 – Tape Measure

1 – Masking Tape and Pencil