Carmanah E Series Kurulum Kılavuzu - Sayfa 12

Radar Carmanah E Series için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Carmanah E Series 16 sayfaları. Traffic beacon systems
Ayrıca Carmanah E Series için: Hızlı Başlangıç Kılavuzu (20 sayfalar), Enerji Yönetim Sistemi Değiştirme Kılavuzu (12 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kullanıcı Kılavuzu (18 sayfalar), Değiştirme Kılavuzu (9 sayfalar), Kurulum Kılavuzu (18 sayfalar)

4.2

Antenna

1. Drill a ½" hole on the top of the solar engine enclosure. Deburr hole and remove all aluminum chips.

a. E Series – on the top of the solar engine enclosure, mark a point 1.13" from the back and 1.50"

from the side as shown.

b. F Series – use the half shear indentation to locate the tip of the drill bit.

Ensure the equipment is not powered during installation. Recheck all wiring prior to energizing

the system.

Ensure all metal chips are removed to prevent system damage caused by short circuits.

Ensure that no burrs are present that would interfere with the antenna seal.

2. Route antenna coax connector cables into enclosure hole and through plastic washer, lock washer, and

nut. Tighten nut securely using crescent wrench.

3. Thread 90° coax adapters onto antenna connectors. Orient as shown (facing upward when installed into

solar engine).

4. Thread coax adapters onto AI FCU connectors. Match GPS & LTE labels on antenna harness & AI FCU

(Cell closer to front, GPS closer to back).

Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 |

APPLIED INFORMATION (AI) INTEGRATION

INSTALL GUIDE

carmanah.com