Forms+Surfaces Aptos Pedestrian Kurulum/Kablolama Talimatları - Sayfa 4

Dış Mekan Işığı Forms+Surfaces Aptos Pedestrian için çevrimiçi göz atın veya pdf Kurulum/Kablolama Talimatları indirin. Forms+Surfaces Aptos Pedestrian 5 sayfaları. Surface mount

Sayfayı Yazdır
APTOS
PEDESTRIAN
™
STEP BY STEP
FOR ALL APTOS PEDESTRIAN LIGHTING
10
e
Install luminaire mounting bolt[s]
• Apply LOCTITE
®
243™ thread locker
or similar on fastener threads of 1/2"-
20 x 1-1/4" mounting bolt[s] (e) and
thread into pole to use as alignment for
luminaire using 5/16" hex bit. Leave at
least 5/8" of threads exposed in order
for luminaire to slide over bolt.
T 800.451.0410 | www.forms-surfaces.com
© 2020 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
11
e
Hang luminaire[s]
• Place the power cable and connector
coming from the body through the middle
hole in the luminaire mounting plate so
that the cable and connector are clear of
the mounting surfaces.
• Hang luminaire[s] on the 1/2"-20 bolts
and align lower bolt holes.
SURFACE MOUNT INSTALLATION & WIRING INSTRUCTIONS
12
Secure luminaire[s]
• Apply LOCTITE
similar on fastener threads of 2x 1/4"-20
x 1-1/8" bolts (f) and tighten to secure
luminaire[s] using 5/32" hex bit.
• Tighten 1/2"-20 x 1-1/4" bolts (e).
f
f
®
243™ thread locker or
page 4 of 5 | 12-08-20