Carmanah EG320 Kullanıcı Kılavuzu - Sayfa 7

Aydınlatma Ekipmanları Carmanah EG320 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Carmanah EG320 13 sayfaları. Eg-series
Ayrıca Carmanah EG320 için: Kullanıcı Kılavuzu (16 sayfalar)

Sayfayı Yazdır

Setting Brightness and

Programming

As part of the installation process, the EG320/EG340

is configured with a fixture current, which sets the

base fixture brightness, and an operating profile,

which controls fixture on/off times and, for some

profiles, fixture dimming.

The current setting for every EG320/EG340 system

is carefully chosen to work together with the operat-

ing profile without consuming more than the available

solar energy in the installation location.

The EG320/EG340 is configured in two steps: 1)

installing the fixture current-setting resistor, and 2)

programming the EMS using the EG320/EG340

Programmer.

Installing the current-setting resistor

The amount of current going to the LED fixture(s) is

determined by the current setting resistor, which is

installed in a sealed holder in the EG320/EG340 EMS

wiring harness. When no resistor is installed, the

fixture current reverts to the lowest possible setting.

The current-setting resistor should be inserted into

the holder during the installation of the EG320/EG340

system (see EG320/EG340 Installation Guide for

details). If this step was forgotten during installation,

the current-setting resistor can be installed by pulling

the resistor holder out through the access hole under

the EMS, removing the cap, inserting the resistor, and

replacing the cap.

The current-setting resistor can be inserted into the

holder in any orientation. Make sure it is seated firmly

in the electrical contacts.

EG320/EG340 USER MANUAL

SEttiNG bRiGhtNESS ANd PRoGRAMMiNG

Programming using the EG320/EG340

Programmer

The EG320/EG340 Programmer is used to upload

(program) the operating profile into the EG320/EG340

EMS. This should be done during installation of the

system (see EG320/EG340 Installation Guide for

details).

Follow these steps to program the EMS:

• Make sure the knobs and switches are positioned

as indicated by the label on the EG320/EG340

programmer.

• Point the programmer at the infrared transmitter/

receiver on the EG320/EG340 EMS.

• Press and hold the Send button on the

programmer.

• Continue to hold down the Send button until the

programmer beeps.

• If the Programmer beeps three times and the green

OK light on the programmer lights, programming

was successful.

• If the Programmer emits one long beep and the red

Error light on the programmer lights, programming

was not successful.

If programming was not successful, try getting

closer to the EG320/EG340 EMS and make sure

you accurately aim the programmer at the infrared

transmitter/receiver on the EMS while pressing and

holding the Send button. Programming can be done

from the ground, but may not work during the middle

of the day, when the strong infrared radiation from

the sun interferes with communications between the

Programmer and EMS.