Advanced Keys AK-PSB06 Kurulum Kılavuzu - Sayfa 10

Uzaktan Çalıştırıcı Advanced Keys AK-PSB06 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Advanced Keys AK-PSB06 15 sayfaları. Push-start ignition system

Sayfayı Yazdır

REMOTE START FUNCTION (OPTIONAL)

A built-in Remote Start function is available when system is connected with an Advanced Keys Smart

Key System. To enable remote start function the following conditions are required:

• Internal Jumpers JP1, JP2 and JP3 are set at their default position.

• Purple "Push-Start Enable" input is connected to AK-104 Smart Key System or newer.

See www.advancedkeys.com for more information.

• System successfully programmed for Tach Ignition and has passed Ignition Testing.

• Neutral Safety Switch input must be connected correctly and passed Neutral Safety Switch Testing

(see below) to provide protection from remote staring in gear other than "PARK" or "NEUTRAL".

Neutral Safety Switch Connection

In most automatic transmission vehicle the shifter has a built-in mechanism that lock-out the starter

and prevent ignition while in drive gear. If vehicle has the built-in starter lock-out, connect Neutral

Safety Switch input directly to ground as shown in Figure A. If the vehicle is a manual transmission or

does not have starter lock-out function, connect Neutral Safety Switch input as shown in Figure B.

To Neutral Safety

Switch Input

Figure A

Once Neutral Safety Switch input has been connected the starter lock-out function must be tested.

Use the following steps to confirm this safety feature:

Neutral Safety Switch Testing

1. Make sure there is sufficient clearance around the vehicle allow for small movement.

2. Make sure there isn't any other active systems connected to ignition.

3. Engage the emergency or hand brake.

4. Turn the key to the ON position to releases the shifter interlock.

5. Place the car in drive (D) and turn the key to OFF position.

6. Without step on the brake pedal, place your foot over it and be ready to step on the brake if the

starter engages.

7. Trigger the remote start via Smart Key remote.

8. If the starter engages, immediately step on the brake to shut the remote start. Verify brake input if

the starter does not shutdown. If the starter does not engage then safety system is working.

Do not return the vehicle to the customer until this safety feature is working properly!

WARNING

Remote Start Ignition Takeover

Use the following steps to takeover from a remote started vehicle without shutting down the engine:

1. Approach and disarm the vehicle with a valid Smart Key.

2. Enter the vehicle without stepping on the brake.

3. Press the push-start button once to switch to ACC mode and wait until Green Status LED light

turns OFF and Backlight turns ON.

4. Step on the brake to exit Remote Start mode and switch to normal RUN mode.

5. Vehicle is now safe to take out of the PARK/NEUTRAL gear for driving.

It is responsibility of this product's installer to ensure that the vehicle cannot be remote started

while it in drive gear. It is user's responsibility to ensure that the vehicle remain in "PARK" or

"NEUTRAL" after remote started to prevent vehicle from moving before taking over the ignition.

Please ensure the remote starter is disabled by toggle OFF the Neutral Safety Switch

WARNING

To Neutral Safety

Switch Input

Neutral Safety Switch

Figure B

Enable/Disable Toggle

input before servicing. (See Figure B)

Park

OFF

Neutral